Results 1 to 2 of 2

Thread: Question on Crown D60 Mono Specs

  1. #1
    Senior Member mark214's Avatar
    Join Date
    Jun 2011
    Location
    Low Earth Orbit Over The Midwest
    Posts
    110

    Question Question on Crown D60 Mono Specs

    Crown's mono spec for the D60 is 70 watts into 16 ohms. No mention of 8 ohm or 4 ohm power.
    I assume it should not be run into a 4 ohm load but is it OK into 8 ohms and the ballpark power in to 8 ohms.


  2. #2
    Senior Member
    Join Date
    Feb 2007
    Location
    Christchurch, NZ
    Posts
    1,400
    As far as I am aware, the D60 was only ever rated into 8 ohms or greater. When an amplifier is in bridge mode, it is usually rated at channel 1 + channel 2, 16ohms. If you run it into an 8 ohm load you will exceed the limits of the output stage.

    Allan.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Crown Vs. Crown..The China Syndrome !
    By jeenie67 in forum Professional Amps
    Replies: 33
    Last Post: 12-17-2016, 09:57 AM
  2. Replies: 8
    Last Post: 07-02-2009, 09:45 AM
  3. Crown Dc 150A and 300a question.
    By matsj in forum Professional Amps
    Replies: 2
    Last Post: 12-05-2006, 04:10 PM
  4. Crown PSA-2X Indicator Lights Mono Mode?
    By toddalin in forum Professional Amps
    Replies: 17
    Last Post: 08-29-2006, 07:40 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •