Crown's mono spec for the D60 is 70 watts into 16 ohms. No mention of 8 ohm or 4 ohm power.
I assume it should not be run into a 4 ohm load but is it OK into 8 ohms and the ballpark power in to 8 ohms.
Crown's mono spec for the D60 is 70 watts into 16 ohms. No mention of 8 ohm or 4 ohm power.
I assume it should not be run into a 4 ohm load but is it OK into 8 ohms and the ballpark power in to 8 ohms.
As far as I am aware, the D60 was only ever rated into 8 ohms or greater. When an amplifier is in bridge mode, it is usually rated at channel 1 + channel 2, 16ohms. If you run it into an 8 ohm load you will exceed the limits of the output stage.
Allan.
There are currently 1 users browsing this thread. (0 members and 1 guests)