Results 1 to 7 of 7

Thread: crossover help sr4738

  1. #1
    Senior Member
    Join Date
    Jun 2013
    Location
    wny
    Posts
    121

    crossover help sr4738

    I acquired a pair of these and the one cab works fine, but the other has the mid out. I know the driver is fine because it works when wired direct. Would a bad cap stop the signal from passing or would it have to be the inductor ? I have tried the speaker connector for fullrange and the biamp ones and nothing from the mid. Here is the schematics if anyone can help . - http://www.jblproservice.com/pdf/SR-Series/SR4738.pdf

  2. #2
    RE: Member when? subwoof's Avatar
    Join Date
    Aug 2003
    Location
    fingerlakes region, NY
    Posts
    1,899

    C1

    check the solder connections on C1 - or it is open.

    put a temp jumper across it to rule out any other cause(s)

  3. #3
    Senior Member
    Join Date
    Jun 2013
    Location
    wny
    Posts
    121
    Thanks , checking it now. One of the solder joints was under glue, warming the solder gun .

  4. #4
    Senior Member
    Join Date
    Jun 2013
    Location
    wny
    Posts
    121
    Sure enough under the glue was the bad joint . Thanks

  5. #5
    Senior Member
    Join Date
    Jun 2013
    Location
    wny
    Posts
    121
    If I were to swap the woofer for a 8ohm 2242 would it mess the sound of the other drivers up ? The 2241's in there are 4ohm .

  6. #6
    Senior Member
    Join Date
    Jun 2013
    Location
    wny
    Posts
    121
    A friend told me he could add a zobel circuit for the woofer ,then I could use the 2242 .

  7. #7
    Senior Member
    Join Date
    Jun 2013
    Location
    wny
    Posts
    121
    I'm biamping these now and they sound much better . I wonder why they had the 2241 going all the way up to 600hz. I am using a dbx 223xl crossing at 240hz the bass sounds much cleaner. I have 4 2245's and 6 2242's . One of these days I am gonna swap them around and try it a pair of those in here.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How to add a tweeter 2405h to a full range system SR4738
    By polac31 in forum Lansing Product DIY Forum
    Replies: 5
    Last Post: 05-20-2013, 05:41 AM
  2. 4722-HF (2432H) to 2226H crossover point/slope (active crossover)
    By Jonas_h in forum Lansing Product DIY Forum
    Replies: 6
    Last Post: 04-25-2012, 12:17 AM
  3. Crossover card for electronic crossover 4430
    By leif in forum Lansing Product General Information
    Replies: 5
    Last Post: 01-11-2011, 07:14 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •