2405H Loose Terminal

[christo]

Hello I have a wee problem with a 2405H

One of the connection terminals just spins. By that I mean the screw underneath the diagram solder tad (not sure what to call it) rotates. As far as I can tell the lead from diagram to the solder tab is intact and still connected. I assume I have to unsolder this joint, bend the solder tad back to get access to the screw to tighten it up, and then re-solder the diaphragm lead to the terminal tab.

Is this the right approach any pointers would be greatly appreciated as I’m no JBL Tech and have never done anything like this before.

[Eaulive]

I assume I have to unsolder this joint, bend the solder tad back to get access to the screw to tighten it up, and then re-solder the diaphragm lead to the terminal tab.

I would follow the same process.