4311 rebuild using L100T xover, etc...

[bakes837]

Hey all - I'm using a set of L100Ts for the front channel on my home theater system. I have the remnants of a single 4311 that a friend gave me - no woofer, mid was torn, tweeter's seen better days. Looking to make it a semi-homogenous sounding center channel to match up with the L100Ts.

I have 2213H (from a 4312B), 104-2, and 035 drivers to go into it, and a spare L100T crossover (was considering modding it to a T3 upgrade, swapping it in to one of the L100Ts, then pulling/modding/swapping, etc.).

Any experience using that driver complement with that crossover? The mid and tweeter should be fine, but the woofer response vs. the crossover is an unknown, at least to me.

Any help would be appreciated - thanks!!!

[Robh3606]

Hello

You could use the 4312D crossover and use the 2213 sealed as a center. That will get the bass bloom out of it and you should have enough contol with the L pads to get the driver levels right.

Rob


http://www.jblproservice.com/pdf/Net...%20Network.pdf

[bakes837]

Thanks - downloaded the xover plan, looks simple enough to rework the existing Xover. Already plan on using a ZilchPlug on the port, which should help the bass bump as you stated. Another weekend playing with speakers - gotta love it!!!