I don't care too much for foam surrounds that also melt with time.
I don't care too much for foam surrounds that also melt with time.
"Most foams are made from polyurethane which ultimately reverts to a liquid sticky state similar to the parent polyurethane paint finish-genere."
The foam I use does not disintegrate or rot - is an improved formula.
Course, you should allready know that
I ended up ordering a 12" square by 1/2" thick piece and it arrived the next day. I cut out a piece the same size as the stock foam and put it in. The 1/4" thick felt probably works just as well. The 5" diameter x 1/2" thick foam for a 2445 from JBL Pro is backordered for a month or two.
No one knows what the thickness of the felt (or foam) should be for JBL 2425H ?
There is nothing either good or bad but thinking makes it so. William Shakespeare
I have to replace foam for felt. What would be the tickness? 1/4 or 1/2?
Oh, very nice, thank you Rusty
There is nothing either good or bad but thinking makes it so. William Shakespeare
IIRC the felt pads in TAD 4" diaphragm drivers are less thick than that.
Foam out. Soft wool felt in.
The solution to the problem changes the problem.
-And always remember that all of your equipment was made by the lowest bidder
There are currently 1 users browsing this thread. (0 members and 1 guests)