From what I've been able to find out on the board and elsewhere, refoaming 128H-1's may not be as straightforward as some others? Any words of wisdom greatly appreciated.
Tks,
Joe
From what I've been able to find out on the board and elsewhere, refoaming 128H-1's may not be as straightforward as some others? Any words of wisdom greatly appreciated.
Tks,
Joe
Measure the cone and provide the correct size to Rick Cobb (looneytune2001 on e-bay) when you order form him.
Follow the directions. If you've done refoams before and know how to do the proper prep work, you're good to go.
disco Duaneage just did a great job on 2 for me, might see if I can point him to this thread if he has any pointers...
However the above info is what I have been told before...
Mark
Changing to Legacy Audio and started with a Silver Screen HD for my center between the 250TIs
Well the cone diameters apparently varied so you need to measure. The RC foams for the 128H were a good fit, after completion the drivers FS was good, a little lower than spec but at least not significantly higher. If foams cause the FS to rise you have to break them in for a while.
Why buy used when you can build your own?
OK Thanks guys.
Joe
Yeah, there can be variations on some cones used at different times during production runs... They might vary by about 1/4" max... So be sure to measure the cones across...
I have some foams marked "128" but I have others marked "2214" which are larger which fit the 128H better, but were not "supposed" to fit but they did, so check for certain.
There are currently 1 users browsing this thread. (0 members and 1 guests)