New to this forum and first time poster.
I recently acquired a pair of 4310WX Control Monitor's - my first pair of JBL speakers. The drivers in both are in excellent condition and functioning properly. Attached is a pic of one of them. The cabs however, are a bit rough and both have damage to the lower right front corner. Right now I am just enjoying listening to them but would eventually like to repair the cabinet damage and possibly recap them. The latter is where I need some advice and information. I have searched pretty extensively but have been unable to come up with a crossover schematic. Apparently the speakers are too old for such a document to be available which seems a bit puzzling to me if it is considered a classic. Could someone please point me to a site where even a hand drawn schematic might be available? Also, since the mid and high L-pads are on the bottom of the speaker, I am wondering if the entire crossover is also located there with access through the woofer opening, or more likely might it be mounted on the inside/rear of the cabinet opposite the speaker terminals where it would be easier to access with a straight shot through the woofer opening? And finally as to advisability. I have recapped a number of other speakers, mostly vintage Infinity's, but was wondering if recapping the 4310's will somehow diminish their historic value. I am not concerned about resale value as it is not my intent to sell them, but just whether or not, since they are fully functional, they should be kept in their "original" form.
Finally, is there an easy way to DeOxit the L-pads without taking everything apart? They are a bit scratchy.
Thanks in advance for whatever information and/or advice anyone is willing to provide.