Just bought Altec Lansing Nine Series II

[dcastle42]

The 5 1/2 Mids are in need of reconing or replaced i stuck a set of Daton Mid i had laying around but would like to find a set of orignal mids any ideas where i could find a set . There stained black but look very good
not sure how to put a Picture in
Thanks Dennis

[MikeBrewster77]

I replied to your earlier post in the other thread.

... congrats on your purchase.

Re: the Altec Lansing 9 Series II, I could be wrong, but I think the mids are 6.5" on these...

http://www.lansingheritage.org/image...ome/page04.jpg

Not sure where you might pick up a set of replacements, except perhaps an online auction site. Are they beyond a recone?

The 5 1/2 Mids are in need of reconing or replaced i stuck a set of Daton Mid i had laying around but would like to find a set of orignal mids any ideas where i could find a set . There stained black but look very good
not sure how to put a Picture in
Thanks Dennis

[boputnam]

...not sure how to put a Picture in

Go to "FAQ" at the top, left.

Then to General Forum Usage.

Then to Attachments and Images - it's all there.

The struggle will be sizing the image to within the limits tolerated.