JBL L100T Tweeter brightness help

[wilb67]

Hello! I'm new to the forum and my knowledge of the complexities of speakers is very limited. So my question is for the professionals of this forum.
I have a pair of JBL L100T's and the 035ti tweeters are too bright for my taste even with the treble turned all the way down on my carver C-1 pre amp. What can I do to tone them down? Add an equalizer? Change something in the crossovers? Any suggestions are greatly appreciated.
Thanks,Will.

[grumpy]

Turnover frequency (affected "Treble" range) for the C-1 might be too high
(8KHz?) to offset what you're hearing. I'll make a humble suggestion:
Sell them and move on to something you like rather than trying to 'fix' them.

It would be very easy to buy more external gear ($$$) trying to fix a design that
doesn't suit your needs. Alternatively, you could affect the entire range of the
tweeter by installing an attenuator/L-pad, but now you're into opening up
and modifying them along an uncertain path.

Describing what you're willing to do to keep the L100T's might net you
a different set of responses/suggestions. Quite a welcome, eh?

[jbl_daddy]

Purchase a pair of L100t3 crossovers, there is a pair on ebay this minute.

[Fred Sanford]

How about the freebie/low-tech trick engineers often used with the Yamaha NS-10s...masking tape and a square of toilet paper. Tape & drape the TP over the tweeter, replace your grille cloth, and see if you have the improvement you're looking for.

Is the room they're in partly to blame?

Otherwise, an EQ should be able to help you, but I don't know your pre to tell you how well that will work (is there a processor loop or tape monitor loop?).

je

[SEAWOLF97]

How about the freebie/low-tech trick engineers often used with the Yamaha NS-10s...masking tape and a square of toilet paper. Tape & drape the TP over the tweeter, replace your grille cloth, and see if you have the improvement you're looking for.
je

I think you are on to something there Fred,, I had some Altec 887A Capri's that had cloth between hf grill & driver ,,,,my Altec friend said it was a factory job, they are all that way....said tweet is too hot otherwise

[duaneage]

Rather than buy new speakers just change the resistance in the high pass for the crossover. try 3 ohms for the series resistance and 12 or 15 ohms for the parallel resistor.