Jumper Gage 9444B Amp

[Zuben]

Does anyone knowthe jumper (wire) gage used for the Octal sockets on the back of the 9444b amp?

Thanks
Mike

[hmolwitz]

As long as it makes good contact I wouldn't worry too much, I used 14 ga solid copper, scraps pulled from romex, if you want to get fancy you can buy a couple of octal sockets and jumper the sockets, I got the plug in crossovers, neat if you can find them.
Harry

[Zuben]

Thanks,

Thank is what I figured I do. I have a 9333B I picked up with 70v octals.

Mike

[Zuben]

I was wondering is I should just leave the 15015A's in place.

The module says bridging transformer but all the lit I have read says it is a Input Balance

I have 4 of these amps running mains and monitors for a band. Only 1 amp has the 15015A modules. (One is an EV but the same amp)

Is there any advantage leaving them in?

Mike

[hmolwitz]

I am absolutely unsure of the function of those 15015A input bridging modules, I am sure they do something to your signal, try posting on the Altec Users group.
http://www.hostboard.com/forums/forumdisplay.php?f=706
Best
Harry

[Zuben]

Harry,,

Your link deadends. I did a google on Altec User Groups and didn't see a URL close

Thanks
Mike

[Goodwill_HiFi]

Harry,,

Your link deadends. I did a google on Altec User Groups and didn't see a URL close

Works fine for me..... must be just you