Does anyone knowthe jumper (wire) gage used for the Octal sockets on the back of the 9444b amp?
Thanks
Mike
Does anyone knowthe jumper (wire) gage used for the Octal sockets on the back of the 9444b amp?
Thanks
Mike
As long as it makes good contact I wouldn't worry too much, I used 14 ga solid copper, scraps pulled from romex, if you want to get fancy you can buy a couple of octal sockets and jumper the sockets, I got the plug in crossovers, neat if you can find them.
Harry
Thanks,
Thank is what I figured I do. I have a 9333B I picked up with 70v octals.
Mike
I was wondering is I should just leave the 15015A's in place.
The module says bridging transformer but all the lit I have read says it is a Input Balance
I have 4 of these amps running mains and monitors for a band. Only 1 amp has the 15015A modules. (One is an EV but the same amp)
Is there any advantage leaving them in?
Mike
I am absolutely unsure of the function of those 15015A input bridging modules, I am sure they do something to your signal, try posting on the Altec Users group.
http://www.hostboard.com/forums/forumdisplay.php?f=706
Best
Harry
Harry,,
Your link deadends. I did a google on Altec User Groups and didn't see a URL close
Thanks
Mike
There are currently 2 users browsing this thread. (0 members and 2 guests)