...so I'm just about to start building my reproduction pair of 4345's & I was wondering if anyone has ever done a pair having the veneer pressed on the MDF before doing the millwork, as opposed to after they're built?
You could take a 48" x 96" sheet...rip it down to about 46" in width, laminate solid walnut on the edges & then once you pressed the veneer, trim the walnut edge to the front profile of the original cabinet...no?
Would this not have been the way they were done from JBL?
I refuse to veneer with contact cement & I can't really think of another acceptable method??
Any comments...tricks...??
I love cabinet making...just not MDF or veneer but I'm anxious to get them built!