OK, so I plan to build a pair of two-way systems that use 2225 and 2445 drivers (2-inch compression drivers).
Are there any special considerations I need to ponder?
I will run them in a 7sq ft box, and plan to passively cross these at 500hz.
OK, so I plan to build a pair of two-way systems that use 2225 and 2445 drivers (2-inch compression drivers).
Are there any special considerations I need to ponder?
I will run them in a 7sq ft box, and plan to passively cross these at 500hz.
how large a horn you can tolerate...Are there any special considerations I need to ponder?
Depending on the horn you may have a issue above 10K. Depends on what you are looking for. Why are you running 2225's in 7 cubic ft??
Rob
"I could be arguing in my spare time"
Well. It is hard if you don't know what to search for. I have been looking for a long time for a two way system for the 2445 drivers - with out luck.
I thank you for these valuable informations. My search is now over and I will start building my second DIY project.
Thanks again
Vernb
But I am still in doubt, because some people here on LH say that you need to compensate the falling HF response of the compression drivers in the x-overs. They do that in S3100 I know, but on the JBL 4673 the x-over doesn't have any kind of compensation. It is just a straight 12db/oktav filter, as I see it.
Is that because the 2445 2" drivers do not roll of in HF like the smaller 2426 1" drivers ??? Are they more linear in their response?
Vernb
There are currently 1 users browsing this thread. (0 members and 1 guests)