Results 1 to 2 of 2

Thread: DIY Altec N1500A

  1. #1
    Junior Member
    Join Date
    Nov 2011
    Location
    Upstate, NY
    Posts
    6

    DIY Altec N1500A

    Hi all, I'm trying to build a set of N1500a's from scratch for a pair of 604e. I've used Markwarts excellent site, but this is my first crosssover from schematic. My question is this: there is no lpad on the parts list, but one is used in the vintage crossovers, is it the 25ohm R-2 component?

    http://home.earthlink.net/~jmarkwart...les/n1500a.pdf
    Attached Images Attached Images  

  2. #2
    Senior Member
    Join Date
    Apr 2003
    Location
    Richmond Hill, Ont.
    Posts
    4,762
    R2 is not an Lpad, it's a variable resistor ( Potentiometer / Rheostat ) .

    This part (from Ohmite) will do the job .




    PS ; I think you should ask JeffM( via his website ) for clarification about installing his HF contour circuit to the N1500a ( since it's mentioned at his web-page but not committed to a drawing ) .

    Quote Originally Posted by JeffM
    The N-1500A with MF EQ?
    I next wondered what the addition of Mid Freq EQ would do to the behavior of the N-1500A filter, so I modified the CALSOD filter model with a contour circuit consisting of a 6uf cap paralleled with an 8 ohm resistor, which was then placed in series with the compression driver voice coil. The mid-point of the resistor was tied to ground with a variable resistance of 10-50 ohms. See Fig. 3 below:

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Altec 508A vs Altec Model 8 series II Help Please !
    By jgscott in forum Lansing Product General Information
    Replies: 3
    Last Post: 03-10-2020, 08:09 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •