HELP !!!!!

[richluvsound]

Hi Folks,
First of all please refrain from laughter until after you have answered my question !!!!!
I'm trying to put my 4333a's back together. I can't figure out which way round the l-pads go.

Does the 8 ohm pot go on the left or the right

TIA ,Rich

[macaroonie]

The 8ohm pad is for the tweet which i think is to the right on the foilcal

[richluvsound]

thanks Mac,

I read your stuff about the veneering . Stick to the sheet glue mate or go with Rick's method . Dump the contact idea IMHO .

Rich

[macaroonie]

You know its the smell of Evostick that I like not the taste.
No that was not really in my mind. Can you post me up a wee sample of that film to get a try at please about an A4 if that would not be too much trouble.

[Fred Sanford]

Does this help?

[macaroonie]

Hey Rich ask and ye shall recieve. That is a good enough image that if you were stuck you could get repro people to run you off a couple.
Top job Fred

[richluvsound]

thanks, Fred and Fanny baws,

[richluvsound]

You know its the smell of Evostick that I like not the taste.
No that was not really in my mind. Can you post me up a wee sample of that film to get a try at please about an A4 if that would not be too much trouble.

I'll post it first thing Monday!

R

[macaroonie]

Speakers are looking tasty. I did my big round over on a couple of edges. Easy peasy although i had to make a 1/2 base plate to allow the cut to run to zero coz the base on the router would not take the dia of the cutter.
The veneer rolls over the curve with ease.
I'm off for a walk now to here -------
I
I
I
I
I
V
http://www.stirlingonvideo.co.uk/pag...bcategoryID=30

[Fred Sanford]

Hey Rich ask and ye shall recieve. That is a good enough image that if you were stuck you could get repro people to run you off a couple.
Top job Fred

I'm sure I got it here, somewhere somehow...glad it could help.

je