Results 1 to 1 of 1

Thread: JBL control 5 modification repair

  1. #1
    JBL 4645
    Guest

    Smile JBL control 5 modification repair

    With some spare parts courtesy of Rich, well here’s tonight’s plan I have two other JBL Control five monitors that have different 6 ½ bass mid drivers in them as the edge foam surround gave up the ghost a few years ago I didn’t have the bottle to fix them and see that the HF drivers voice coil got overdriven which resulted in a burnt out HF I was rather depressed for weeks.

    So I have these other HF drivers that sit on top of them that seem to work, there from an Eltax tower range which is placed to the left-hand side of the room.

    Now I plan to make minor repair to the bass mid driver which as a slight bit of damage to the edge foam surround, hopefully a small amount of silicon rubber will seal the wound kinder like putting a plaster on cut finger.

    If all goes will I should have these up and running within a few hours if all goes well.
    Attached Images Attached Images  

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. JBL Control 1E
    By Guido in forum Lansing Product General Information
    Replies: 5
    Last Post: 09-28-2007, 06:07 AM
  2. Noticeable differences JBL Control Series - wire gauge
    By JBL 4645 in forum General Audio Discussion
    Replies: 3
    Last Post: 10-01-2006, 01:20 AM
  3. JBL SA 660 amp repair parts
    By Gary Wolf in forum Lansing Product Technical Help
    Replies: 2
    Last Post: 05-12-2006, 01:31 PM
  4. JBL 12'' Needs Repair
    By vifa32144 in forum Lansing Product Technical Help
    Replies: 4
    Last Post: 03-10-2005, 09:33 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •