+ Reply to Thread
Results 1 to 5 of 5

Thread: Reconing 2202H?

Hybrid View

  1. #1
    Electric Banana
    Guest

    Reconing 2202H?

    Hi! Forgive me if this question has been asked before. I'm trying to have a look at the voice coil of a 2202H midrange and I can't work out how to get into it. There are no screws on the back of it. Any ideas?

  2. #2
    Senior Member
    Join Date
    Jul 2003
    Location
    missouri galaxy
    Posts
    1,291
    You cant without destroying it.
    Vlad

  3. #3
    Senior Member Fangio's Avatar
    Join Date
    Oct 2005
    Location
    Germany
    Posts
    778
    A tad longer answer would be - I think they are hold together by the power of the magnet (and probably glue). So demagnetization would be theoretically the only way, and later recharging. I've never seen that recommended on this site.

    If you're just curious, or a reconing is predictable/required, you can have two looks or three at a recone kit.

  4. #4
    Electric Banana
    Guest
    Thanks for the replies. I assume that this applies for similar speakers? I've pulled apart a MR822 and a MR825 and the speaker components are the same with no way in.

    The speaker is scratching, so I was hoping to have a look inside and clean up all the foam residue that has probably clogged it up.

  5. #5
    Administrator Robh3606's Avatar
    Join Date
    Apr 2003
    Location
    Destiny
    Posts
    7,467
    You could always cut open the coil cap and redo it with a slightly larger cap as an option. You will only see the one side but you could then clean out what you can and get the rest of the loose foam out of the driver and pole piece vent.

    Rob

+ Reply to Thread

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Good shop in usa for reconing kits.
    By matsj in forum Lansing Product Technical Help
    Replies: 9
    Last Post: 09-19-2006, 03:36 AM
  2. JBL reconing services needed urgently!
    By Sausagefingers in forum Lansing Product Technical Help
    Replies: 3
    Last Post: 11-21-2005, 10:11 AM
  3. Reconing a D130F
    By Paul Bennett in forum Lansing Product Technical Help
    Replies: 4
    Last Post: 03-15-2004, 08:37 AM
  4. 2202h in 4355
    By Dwight in forum Lansing Product General Information
    Replies: 5
    Last Post: 10-11-2003, 07:36 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts