Results 1 to 2 of 2

Thread: 60 hz hum & Ebtech Hum Eliminator

  1. #1
    backbeat2000
    Guest

    60 hz hum & Ebtech Hum Eliminator

    Anyone out there know anything about these:

    www.ebtechaudio.com

    We're running 2 & 3 way, JBL/Altec, crown, BGW, Rane x-over w/ 24Db slope, Rane MP 24 mixers, all balanced lines @ +4, sources are pro dj cd players w/unbalanced outs, low z mics.

    All one nighters........one night no hum, next night hum's back

    ground lift on crowns is no help, have isolated components from racks etc..

    Any ideas will be much appreciated!!

    Thanks,
    Bill
    Last edited by backbeat2000; 01-21-2004 at 08:59 PM.

  2. #2
    Senior Seņor boputnam's Avatar
    Join Date
    Apr 2003
    Location
    northern california
    Posts
    7,007

    Re: 60 hz hum & Ebtech Hum Eliminator

    Originally posted by backbeat2000
    We're running ... pro dj cd players w/unbalanced outs ...
    This might be your (intermittent) source. Ground loops are tough.

    One night you get set early (yea, right!), leaving everything on, start un-plugging from the source(s) toward the amps. Keep the gains low, and as you take the signal chain apart (working toward the amps) note the change in the ground-loop as you do it. Then work on that part of the chain that produces the GL.

    My suggestion is to also try some custom cabling where you drop the shield/ground at the next component. Say, for instance with the unbalanced outs, as you wire those into the next component (say, the board), drop the shield (that's right, only use the tip/signal). In some racks, we've had to drop the shield/ground AT each next input (from CD player to board/pre-amp, board/pre-amp to crossover, crossover to amps) before we could lose the ground loop for good.

    We had a 'round with this a while back:
    Consumer and Pro gear - Connectivity (Link) You might also Search the Forum for "Ground Loops" - we've all had 'em...

    Oh, and I WOULD NOT lift the ground on those Crowns...
    Good luck!
    bo

    "Indeed, not!!"

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •