I debated where to put this and other than another forum, this seemed safest.
Can the magnets in JBL compression drivers be replaced in the field. (by a shop counts)
Are exact dimensions given anywhere?
Does anyone Know for sure if you can use an electric discharge mill on neodymium without demag (I would suspect so but do not know for sure)
Can neodymium be field annealed / hardened or does any machining have to be done by grinding.
I'm not asking anyone to do any research. If you know an answer and could take the time to post that would be great . If not ok. If you know where an answer might be and want to post that that would be great also.
thank you