+ Reply to Thread
Results 1 to 4 of 4

Thread: Tangerine Phase Plug Glue

  1. #1
    Junior Member
    Join Date
    Aug 2006
    Location
    Oxford. Michigan
    Posts
    12

    Tangerine Phase Plug Glue

    I recently replaced the diaphragms in my Altec 902-8A's. On one of them, the tangerine phase plug is loose. It looks like it was glued to the magnet structure originally. When reassembled with the plug loose, it produces a distorted sound.

    What should I use to glue this plug back in place?

    Thanks.

  2. #2
    Senior Member
    Join Date
    Jun 2004
    Location
    NY Catskills
    Posts
    588
    I have seen this allot and think it is the result of the dissimilar materials used. Metal and plastic are affected differently with changes in temperature.
    Clean the old glue off both the post and the plug and re glue with a very thin coat of two part epoxy. Carefull not to use too heavy a coat that it oozes into the slits or down into the gap.
    You might also double over a piece of masking tape with sticky side out and use it to clean debris between the gap.
    Keep your drivers in a temperature controlled area. I find loose tangerines almost always where speakers are stored in unheated garages or storage areas.

    Gary

  3. #3
    Senior Member
    Join Date
    Sep 2005
    Location
    Arkansas
    Posts
    791
    The plastic plug is the tricky bond, pretreating it with the proper solvent is the key to a good bond. The best such product available to consumers is Loctite Plastix, a cyanocrylate packaged with a separate plastic primer component.

    For less-critical plastic bonding, PVC primer applied before any common super glue works well for the same reason, but I'd hesitate to try it on a tangerine (might melt it).

    Obviously, any old glue residue must be removed, there's no tolerance for improper placement.

  4. #4
    Junior Member
    Join Date
    Aug 2006
    Location
    Oxford. Michigan
    Posts
    12
    Thanks for the advice. Loctite Plastix is now sold under the name Loctite Super Glue - All Plastics. It seems to have done a nice job of bonding the plastic plug to the steel surface. I used paper shims in the voice coil gap to help center the plug. The distortion I was having is now gone.

    Thanks.

+ Reply to Thread

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Zilch Cloth Installation
    By saeman in forum Lansing Product DIY Forum
    Replies: 46
    Last Post: 06-03-2010, 09:13 PM
  2. 2420 is misaligned, phase plug off center, or top plate is, how to adjust?...
    By transducergeek in forum Lansing Product Technical Help
    Replies: 10
    Last Post: 08-26-2005, 04:35 PM
  3. altec 19 tangerine phase plug
    By Audiokarma in forum Lansing Product Technical Help
    Replies: 2
    Last Post: 07-02-2004, 12:29 AM
  4. Phase Plug Renderings
    By johnaec in forum General Audio Discussion
    Replies: 6
    Last Post: 03-15-2004, 07:13 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts