Hello,
I would like to replace frequencies on N250 network crossover.
Anybody can explain me filters used on this network ??
Wich filters used on it ??
Thank you,
Regards,
Hello,
I would like to replace frequencies on N250 network crossover.
Anybody can explain me filters used on this network ??
Wich filters used on it ??
Thank you,
Regards,
JBL 250TI (modified)
2x 20W EL84
2x 400W MosFet
CD-722 (Modified)
Active crossover (below 400Hz)
LS-22 DIY preamp (in progress)
Aleph 3 (in progress)
DAC 5 Audio Note (in progress)
You want to change the crossover frequencies?? The best explanation is a post Giskard did where he went into detail showing the voltage drives and explained the use of each part in the crossover. Really an excellent tutorial. Not the same network but it's plenty informative anyway.
http://www.audioheritage.org/vbullet...&highlight=250
Rob
Rob,
Thank you for your advice.
I will do that...
Regards,
JBL 250TI (modified)
2x 20W EL84
2x 400W MosFet
CD-722 (Modified)
Active crossover (below 400Hz)
LS-22 DIY preamp (in progress)
Aleph 3 (in progress)
DAC 5 Audio Note (in progress)
There are currently 1 users browsing this thread. (0 members and 1 guests)