Hello
I woild like to kwow what is the connection between Dcr and impedance in a loudspeaker .
Some people have an 8 ohms impedance and a 6.3 ohm Dcr as example !
Thank you
Gerard
Hello
I woild like to kwow what is the connection between Dcr and impedance in a loudspeaker .
Some people have an 8 ohms impedance and a 6.3 ohm Dcr as example !
Thank you
Gerard
DCR is the actual measurement you get with an ohm meter when testing across the leads with the speaker unconnected and at rest. The "nominal" impedance is an "average" rating based over the speaker's normal operating frequencies. Points along this line may be above and below the average value.
John
Thank you johanec
Does it mean if I have a 16 ohms rated speaker ( J model ) and 9.8 dcr , the speaker will be more like an 8 ohms ( H speaker ) ? Will that influence the crossover frequency ?
Gerard
You should have an impedance sweep done. That 9.8 might be the minimum point. The crossover should probably be designed for the impedance at the crossover point.
John
DCR = DC ( 0 hertz) resistance. This is what the actual resistance of the wire in the coil is. This can be all over the map and does NOT always track the impedance
Impedance = the **AC** ( measured and averaged over a range of frequencies ) "resistance" a component, network or system has.
This can go up and down depending on many factors but usually the average is specified.
In the case of the large 4" JBL coils, the DCR is around 6.2 for an *8* ohm speaker.
9.8 is right in the ballpark for a *16* ohm speaker.
sub
To understand better what they are saying about the impedance rising and falling proportional to frequency, when you have the ohm meter connected to the woofer, gently push the cone forward from the backside, and watch the meters display read out all kinds of crazy numbers.
Its sort of an idea of whats going on when the woofer is actually playing music. Impedance is nominal, not exact.
scottyj
pushing in a cone is the same as talking into a dynamic mic. The coil moves in a magnetic gap which creates a voltage.
this has nothing to do with impedance. the ohmmeter's internal voltage is added to or subtracted from what the motor generates.
sub
But doesnt impedance fluctuate as the woofer plays signal? I understand that what Im saying isnt actual impedance, but it sort of gives an idea of how the impedance fluctuates with signal, motion, and frequency. I did say " sort of "!Originally Posted by subwoof
As the woofer moves in and out to signal, the impedance doesnt fluctuate, varying with frequency?
scottyj
Sure it does Scotty.Originally Posted by scott fitlin
Look at any of the impedance plots in the forum and you'll see that actual impedance is dynamic.
Edgewound...JBL Pro Authorized...since 1988
Upland Loudspeaker Service, Upland, CA
There are currently 2 users browsing this thread. (0 members and 2 guests)