Okie Dokie!
Quest Complete!
Okie Dokie!
Quest Complete!
There is a pair of Magnat behind ?
Eckhard
Puaaaahh,
no magnats needed. JBL is able to go for it.
Ralf
16 Hz can not be substituted
But what do you do with this ??
Eckhard
with what?Originally posted by paragon
But what do you do with this ??
Eckhard
16 Hz can not be substituted
Doen`t think bad about Magnat.
Look at Ebay what they get for their "Ribbon Series".
I get an old pair of Superbull II (mid 70`s) and they sound
very good. Alnico magnets on the low drivers !!
Look !!
The sidewalls are made of 3 !! cm sandwhich wood.
And the front and back are made of 2 cm wood.
Is that bad ??
The front is also fixed with a samt(?) cloth.
Is this bad??
Eckhard
sounds good, Eckhard. Nobody has said something bad about Magnat...Originally posted by paragon
The sidewalls are made of 3 !! cm sandwhich wood.
And the front and back are made of 2 cm wood.
Is that bad ??
The front is also fixed with a samt(?) cloth.
Is this bad??
Eckhard
16 Hz can not be substituted
Yes,
You are right !!
Eckhard
WOW!!!
I remember when I first recvd my 4648's from the tent sale(JBL pro) and set them up hozontially on the floor/wall boundry and used Rane AC-22 crossover set for low-pass 120hz on the 4 2226J's in 4648 cabs.
I powered them with a Carver TFM-35 (250 watts/chnl) to break them in. I played all kinds of music(mostly non high quality music unfortunately).
I have a 12' X 16' living room with 8 ft ceiling. I went outside to see how much sound was leaking out to the world outside( my neighborhood).
I felt the stucco exteriorer outside the house, came in and shut down the system, and that was the last time I had a quad of 2226's running hard in my house.
I know some of you out there are wondering why I am getting 2242's to run in my house. Well my normal listening is not that loud, and other than breaking in the 2242's, I will not run at "home-destructive" levels.
It will be a rough time breaking those 18" 2242's in as I am only using 75watts/chnl at 80hz on down to mesh with my Edgarhorns. The midbass horn is only good down to 80hz, hence the subs to finish off the bottom octave.
I found a really interesting point that was brought up in this thread that I totally forgot about. Lowering the tuning frequency by plugging up on of the ports in my cabinets. I no longer have anything more than 250 watts in the house anymore(tube amp junkie), and those are sub-plate amps. My next in line amp is the Sansui AU-7900 I just had reworked and modded recently(75wpc).
Thanks to all in this intruiging discussion, it goes to show the search function will give you tons of info if you use it!!!!!!
Ron
There are currently 1 users browsing this thread. (0 members and 1 guests)