Search:

Type: Posts; User: toddalin; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.58 seconds.

  1. Come See My Garden Railroad on June 23, 2019 in Orange County, CA

    Tortoise and Lizard Bash Garden Railroad (T&LBRR)

    Sunday, June 23, 2019

    1:00 P.M. – 4:00 P.M.

    Santa Ana, CA 92705

    PM for Address
  2. ~12 feet to camera and ~10.5 feet to SLM. Maybe...

    ~12 feet to camera and ~10.5 feet to SLM. Maybe just a couple dB louder than I typically listen to this song at because it makes a better recording.
  3. Guinevere by CS&N Through the Ethyl Mermans

    Guinevere by CS&N with SLM displaying the peak "A-weighted" levels for normal listening levels through the Ethyl Mermans.A standard CD through an Oppo95 and Yamaha RX-Z9 receiver. No subs, eq, or...
  4. Replies
    7
    Views
    483

    Another problem with the Nyquist method that I've...

    Another problem with the Nyquist method that I've never seen addressed, is sampling white noise.

    Assuming the white noise source consists of all frequencies from 20 Hz-20kHz there is more than a...
  5. Replies
    7
    Views
    483

    A good video, but does not address what I asked...

    A good video, but does not address what I asked about in the least (e.g., once the signal is sampled, how is that sample assigned a "1" "0" pattern and how can that pattern be mathmatically...
  6. Replies
    7
    Views
    483

    Doesn't even begin to explain what's going on,...

    Doesn't even begin to explain what's going on, and neither do other articles.

    Fine on the sample rate..., but what happens next?

    How is that sample quantified into a series of 1's and 0's and...
  7. Replies
    9
    Views
    559

    Would still come through the resistor at a...

    Would still come through the resistor at a reduced level.
  8. Replies
    9
    Views
    559

    Thanks Rob. I think you have the 0.9 mH as 900...

    Thanks Rob.

    I think you have the 0.9 mH as 900 mH (or such).

    Note that the 12 mfd on the Heil actually pulls it quite low into the 2251 territory. This was to get the best transition based on...
  9. Replies
    9
    Views
    559

    Thanks Rob! I don't think that you are...

    Thanks Rob!

    I don't think that you are considering the effects of the inductance of the 2241H (R2) on the 2251J and that it's slope is steeper than shown. This inductance seems to change the...
  10. Replies
    9
    Views
    559

    Truely Interesting Situation

    Truely an interesting situation.

    The inductance/impedience of the 2241H woofer is creating a second order filter for the 2251J mid. When the 2241 woofer is disconnected, the slope on the mid...
  11. Replies
    9
    Views
    559

    Actually, can someone model what's going one...

    Actually, can someone model what's going one here? Seems like it could be interesting.

    Thanks
  12. Replies
    9
    Views
    559

    Ethyl Merman Crossover Schematic

    After much listening, tweaking, changing, and even an unintentional mistake that led to the final product, this is the current crossover schematic for the 2241H/2251J/Heil AMT.

    The unintentional...
  13. According to WinISD the box is tuned to 27.15 Hz....

    According to WinISD the box is tuned to 27.15 Hz. Plots are below with 2241H in green and 2242H in white.

    One needs to recognize that the plots are based on the roll-off from the average signal,...
  14. OK, using JBLs specs of 225 liter box tuned to 25...

    OK, using JBLs specs of 225 liter box tuned to 25 Hz. But this is probably erronious and they should have specified the vent dimensions to get the actual tuning.

    Think about it..., the dynamics...
  15. BTW, there is another issue that need to be...

    BTW, there is another issue that need to be addressed and has been totally ignored. That is, what are the other drivers to be used?

    The 2242 is so efficient that you will need to use it with some...
  16. Again, WinISD optimizes the box for the driver's...

    Again, WinISD optimizes the box for the driver's T/S parameters. The 2241H is in a 10.7 cu ft box tuned to 35.3Hz. The 2242H is in a 3.0 cu ft box tuned to 50.85Hz. The 2245 is in a 7.7 cu ft box...
  17. I am letting WinISD do its own comparison based...

    I am letting WinISD do its own comparison based on whatever WinISD bases it's comparisons on.

    By program default, if nothing is changed (e.g., box size/tuning) all drivers are shown in their...
  18. Well there you go. :skeptical: Requires a...

    Well there you go. :skeptical:

    Requires a different box and different tuning to take advantage of its capabilities. WinISD results are included!

    Red is 2245H, Green is 2241H and White is...
  19. Replies
    0
    Views
    293

    Let's See Those Heil Stands!

    I know they are out there but have yet to see one of the new smoked acrylic models unwrapped. :dont-know: They all sold and I didn't even get a demo piece for myself.
  20. Pros and cons 2241H is by far the cheapest and...

    Pros and cons
    2241H is by far the cheapest and most readily available. 2245..., not so much.
    2241 goes lower than 2242. Forget watts, that's not an issue here.
    2245 will require a refoam every...
  21. No. I've not listened to the Altecs that much...

    No.

    I've not listened to the Altecs that much because the Soundcraftsmen has an audible hum, and if I don't use that, I need to get another amp to tri-amp them.
  22. A New Clarity to an Old Standard Brings a New Meaning

    How many times have you heard Sunshine of Your Love by Cream? Maybe too many to count.

    But the other day was the first time that I ever listened to it over the Ethyl Mermans (JBL 2241H/2251J/Heil...
  23. Replies
    15
    Views
    1,089

    Thanks

    Thanks
  24. Replies
    15
    Views
    1,089

    Different T/S parameters. ...

    Different T/S parameters.

    http://www.jblproservice.com/pdf/Thiele%20Small%20Parameters/Theile%20Parameters.pdf
  25. Replies
    0
    Views
    420

    Ethyl Gets a Bra

    I made a pair of grills/covers for the 2251Js used in the Ethyl Mermans. The cloth is sandwiched between two pieces of veneer cut on the laser table. The inside piece of veneer has four 1/4" holes...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4