Search:

Type: Posts; User: yggdrasil; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.25 seconds.

  1. Replies
    1
    Views
    1,056

    Note from similar setup (375 instead of LE85)...

    Note from similar setup (375 instead of LE85) was:

    N7000:
    1: green
    2: black
    3: black
    4: red

    LX5:
    1: green
  2. Replies
    25
    Views
    5,799

    I believe that big Iwata was designed for the 3"...

    I believe that big Iwata was designed for the 3" 2490.

    So - the goal is to use one horn from ~500Hz to 10KHz.

    As you mention - the Yuichi 290 should be a good choice. Designing a bigger horn...
  3. Replies
    25
    Views
    5,799

    Isn't narrow dispersion a HF issue? @Dr.db:...

    Isn't narrow dispersion a HF issue?

    @Dr.db: Did you say anything about the high crossover point?

    Here's a picture of an Iwata horn used from ~200Hz if I remember correctly:...
  4. Replies
    664
    Views
    516,209

    Sticky: There is only one other pair starting with...

    There is only one other pair starting with J1079-. They are dated 1995.
  5. Replies
    15
    Views
    2,669

    If my memory serves me right nearfield...

    If my memory serves me right nearfield measurements should be taken at 1/2 inch (1cm).
  6. Replies
    9
    Views
    3,423

    I was using a Nelson Pass Zen 9 (F3) which is 15...

    I was using a Nelson Pass Zen 9 (F3) which is 15 watt. This amp was not the limiting part of the setup.
  7. Replies
    9
    Views
    3,423

    I have run 476Be with a series cap for...

    I have run 476Be with a series cap for protection. Cap was large enough to be outside crossover frequency.

    Anyway - you do not need any high power amp for these drivers.
  8. Replies
    21
    Views
    4,026

    Registry records suggest your Paragon is from...

    Registry records suggest your Paragon is from 1980 or 1981.
  9. Replies
    38
    Views
    19,298

    Now you have the link to vBulletin's forum. They...

    Now you have the link to vBulletin's forum. They have the right knowledge to give you any more than educated guesswork.

    Back to your problem. Here's my 2 cents worth of guessing:
    1) Somewhere in...
  10. Replies
    38
    Views
    19,298

    Here you are @ just 45 minutes:...

    Here you are @ just 45 minutes: http://www.vbulletin.com/forum/search?q=remember+me&searchJSON=%7B%22keywords%22%3A%22remember+me%22%7D
  11. Replies
    41
    Views
    28,434

    Maybe these guys is willing to help:...

    Maybe these guys is willing to help: http://www.simplyspeakers.com/jbl-speaker-repair.html
  12. Replies
    25
    Views
    8,734

    Vemodig vakkert!

    Vemodig vakkert!
  13. Replies
    58
    Views
    12,651

    Signal to noise ratio to low. Closing this thread.

    Signal to noise ratio to low. Closing this thread.
  14. Replies
    2
    Views
    856

    The next step would be to design and build new...

    The next step would be to design and build new crossovers.

    Other changes are more intrusive, in which case, you could just as well start from scratch.
  15. Replies
    664
    Views
    516,209

    Sticky: Close to 1975

    Close to 1975
  16. Replies
    30
    Views
    8,072

    Some amplifier design's has this turn-on thump. ...

    Some amplifier design's has this turn-on thump.

    A few years back I had a Norwegian amplifier with turn-on thump. The designer offered an upgrade, and when I called to make the appointment, I had...
  17. Thread: 4 Way Build

    by yggdrasil
    Replies
    10
    Views
    6,240

    I have a Behringer ECM8000, but today I would...

    I have a Behringer ECM8000, but today I would probably get a USB microphone like e.g....
  18. Thread: 4 Way Build

    by yggdrasil
    Replies
    10
    Views
    6,240

    I have run 2245's in bass reflex earlier. Had to...

    I have run 2245's in bass reflex earlier. Had to move them ~1m out from the wall, and at least 10cm up from the floor.

    Getting them right demanded a lot of measurements and moving around. The...
  19. Thread: 4 Way Build

    by yggdrasil
    Replies
    10
    Views
    6,240

    Do you consider 90dB slopes to protect your...

    Do you consider 90dB slopes to protect your 2446's?

    If so - I'm quite sure they will handle more than the listener.

    Sound-wise - I believe more complexity will give you less details / nuances.
  20. Thread: FlexiSpeaker

    by yggdrasil
    Replies
    6
    Views
    2,304

    @Pos: Haven't tried current amp yet. It's on the...

    @Pos: Haven't tried current amp yet. It's on the ToTry list.

    @NickH: The crossover uses 4-pole Sallen-Key filters. Would you like a detailed writeup on the complete crossover?

    Comparing the...
  21. Replies
    2
    Views
    2,188

    The registry does not have enough drivers with...

    The registry does not have enough drivers with date info to be of any help.
  22. Thread: FlexiSpeaker

    by yggdrasil
    Replies
    6
    Views
    2,304

    More pictures

    More pictures
  23. Thread: FlexiSpeaker

    by yggdrasil
    Replies
    6
    Views
    2,304

    FlexiSpeaker

    This part of my sound system journey started around 8 years ago. The old 4-ways was too constraining, being a single box. I also wanted to move away from passive crossover, because it changes with...
  24. Replies
    5
    Views
    2,353

    In my experience new surrounds will give you...

    In my experience new surrounds will give you functional drivers. Recone gives you new drivers.

    For critical listening the best choice will be recone.

    Good luck.

    Johnny
  25. You could just add a resistor in series with the...

    You could just add a resistor in series with the driver. 4-8 Ohm should get you close.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4