Present...I've been clean for 2 days again.....oh wait....sorry wrong meeting ....I'm still around just more of a looker though.
Type: Posts; User: LHorn; Keyword(s):
Present...I've been clean for 2 days again.....oh wait....sorry wrong meeting ....I'm still around just more of a looker though.
I realize this thread is a few years old but I'll cast my vote for the Crown XLi's. I have been running two XLi 2500's for a couple years now. One is driving my 250Ti's and the other drives my...
I was looking at the 1986 Ti brochure and found this interesting. JBL states that the diamond pattern in the surround and the ribs in the dome raises and lowers the resonant frequencies to above and...
Right...I guess it makes sense..if the ringing would be caused by waves bouncing around under it the foam wouldn't necessarily need to be touching the dome...just like the insulation in a cabinet...
Sorry to butt in here..but I have 8 of the 044Ti's to refoam as well. My question is this...is the foams purpose to mechanically dampen the dome from resonating or is it to block sound waves from...
Am I seeing that right...you're leaving 3 120ti's behind? They are the hardest to find of the Ti series.
No expert here but a spinning screw is a likely suspect. You dont need to take the crossover out to check that...just pinch the 6 white pegs holding the top circuit board on and raise it up...see...
Does anyone have a 240Ti or 250Ti grille peg off their grille to get me an accurate dimension? I know the 120Ti is a ball type peg and 18Ti is the same except the 18 is molded into the grille itself....
I painted it on Jan 20th...and it is very quick drying..like 10 minutes. On my test piece of aluminum I have to really try hard to scrape it with a fingernail. I dont think it is as hard as the...
I see...I figured there had to be some way to align the vc since it cant be shimmed. To be sure I have this right...I do have a 10k uF cap..same thing right?
Thanks DavidF.
After looking at that pic again...I'm not sure I got it yet. The tapered head of the screws cant reach that far down to center the plinth can it...it will only center the top plate?
So lets say...
Thank you...and yes I went with Amazon.
Thanks for the tips badman and Michael Chavez.
I finally got around to painting this driver. The paint Mr. Widget recommended is spot on..thank you for that. Freshly done it doesn't look exactly...
I see...so the tapered screw heads are actually doing the centering. That is the part I couldn't grasp knowing there is always some play with anything that a screw or bolt goes through. I would have...
I found it on Amazon too..has the same Part Number K01613A07 as the Grainger's link you gave...
That sounds right..I knew it wasn't flat and definitely not gloss..so satin was all I could think of. Semi-flat makes sense. Yes I always practice on something to get used to the way the spray...
Yeah I understand I wont get exactly the same thing JBL used...just wondering if anyone has found a very good substitute. This is where I'm talking about..basically the area you see when the woofer...
I need to restore the outside face and edges of my LE14H-1's. Is there a known paint that matches the original? From what I can tell its like a satin black type paint. I would like to get something...
Hello everyone..I realize this is an old thread but there's one thing I cant grasp on this procedure. On reassembly..how do you get the voice coil centered? I have done LE14H-1's no problem..but I...