Search:

Type: Posts; User: Mike Caldwell; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Post some general pictures of the parts and...

    Post some general pictures of the parts and pieces, you may find your market for it is right here!
  2. There's slim but possible chance that Amcron in...

    There's slim but possible chance that Amcron in Elkhart Indiana could still help.

    They were the industrial division of Crown and are still located in the original location.
    I know they will still...
  3. The EV Sentry III series had an external...

    The EV Sentry III series had an external processor called the "SEQ" while you didn't need to use it though you should use it with them, among what it did was let you operate the speaker in what EV...
  4. Replies
    4
    Views
    994

    Any chance the leads are shorted to the body...

    Any chance the leads are shorted to the body after they were soldered to the terminal.

    When tightening the phase plug / bullet if it turns you most likely will wrinkle the diaphragm.
  5. Here's a link to a post I made about acoustic...

    Here's a link to a post I made about acoustic crossovers.

    http://www.audioheritage.org/vbulletin/showthread.php?42183-Looking-For-More-Punch-From-My-2245-4345-Clone/page4
  6. Actually you may want to try under lapping the...

    Actually you may want to try under lapping the crossover frequencies some, that will help with the phase response and frequency response around the crossover point.

    Keep in mind the crossover...
  7. The gray boxes look like a custom build....maybe...

    The gray boxes look like a custom build....maybe they could have been a custom shop JBL build.

    The black box looks like a SR series clone or a modded SR cabinet.

    Post a picture of the...
  8. Replies
    16
    Views
    3,696

    I still use blocking caps on HF drivers and the...

    I still use blocking caps on HF drivers and the days of powering them with DC300's are long over.

    If I'm not mistaken the Crown manual had a schematic for a relay DC protection circuit to put...
  9. Replies
    16
    Views
    3,696

    Do both channels of the amps sound the same? ...

    Do both channels of the amps sound the same?

    Keep in mind the DC (direct coupled) 300 has no coupling caps in the signal path, not saying there could
    be a few other small electrolytics that...
  10. I'm going say for home the 60 X 40 2385 horn may...

    I'm going say for home the 60 X 40 2385 horn may be a little narrow, the 2380 at 90 X 40 or even the harder to find 2382 that is a 120 X 40.

    I use the 2385's in some of my double 12 PA cabinets...
  11. Replies
    16
    Views
    3,696

    AE Techron was the industrial amp division of...

    AE Techron was the industrial amp division of Crown, some of the original Crown audio techs also work there
    now.
  12. Replies
    11
    Views
    1,833

    Check the that speakers are wired correctly /...

    Check the that speakers are wired correctly / polarity. Use a 9 volt battery and touch it across the speaker terminals and see the speakers both move in the same direction.
    With those woofers...
  13. For what it's worth I always felt the DH1a and...

    For what it's worth I always felt the DH1a and it's variants sounded better than a 2445.
  14. Replies
    8
    Views
    1,525

    Here's a couple custom Showco / Clair horns. I...

    Here's a couple custom Showco / Clair horns. I got a few of these and never found a use for them.
    Not sure who made them, laminated fiberglass with balsa wood dampening and support.
  15. Replies
    8
    Views
    1,525

    I'm going to say those were part the Showco Prism...

    I'm going to say those were part the Showco Prism system, Showco was later bought by Clair Brothers.
    Here are a couple links....
    I think there was a long throw cabinet as well.
    ...
  16. Replies
    6
    Views
    2,559

    Those are part of the JBL Array series 4892 trap...

    Those are part of the JBL Array series 4892 trap boxes based on the 14 inch woofers. The one woofer cone is separated around the dust cap.
    They were a mid 90's era model.
  17. Replies
    4
    Views
    2,027

    With that test it sounds like the driver is OK. ...

    With that test it sounds like the driver is OK.

    Check the connections on the level control switch the resistors and for any broken
    wires, you should be able to get to those with the crossover...
  18. Replies
    4
    Views
    2,027

    Could be the crossover, have you tried swapping...

    Could be the crossover, have you tried swapping the driver with a known good working one from another speaker?
    Do a tone sweep test with a small amp directly connected to the driver.

    Chances are...
  19. Think of the low and high level controls kind of...

    Think of the low and high level controls kind of tone controls, the level control on the 3105 for the level of the extra shimmer from tweeter.

    Start the with the low high levels on the crossover...
  20. Replies
    48
    Views
    12,764

    I use the B&C 12PE32 in my double 12 mid hi...

    I use the B&C 12PE32 in my double 12 mid hi boxes, a very clean dynamic light weight cone mid bass
    speaker and very efficient at 101db.

    My stage monitors are loaded with JBL 2262 and 2265...
  21. Replies
    7
    Views
    3,112

    The diaphragm in the third picture from the top...

    The diaphragm in the third picture from the top looks like someone has repaired the voice coil leads.
    The lead on left looks to be soldered back together and the one on the right looks like a...
  22. Good to hear you have the amps up and running. ...

    Good to hear you have the amps up and running.

    Do you have a high pass filter on the system that could help the woofer from bottoming out.
    Careful, those amps have a fair amount power for those...
  23. As for the left right issue what happens when you...

    As for the left right issue what happens when you swap the cables at the input to the amp?
  24. Couple things here...... First you CAN NOT...

    Couple things here......

    First you CAN NOT disconnect the Fan on the MA2402.
    The fan in those is a one of kind fan, they actually call it a "fanformer" the windings on the motor assembly
    are...
  25. I would try them the other way around as well. ...

    I would try them the other way around as well.

    Actually you could wire opposite so one side of your system has the 2402 on the lows and the K2 on the top
    and the other side K2 on the lows and...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4