Search:

Type: Posts; User: Guenter; Keyword(s):

Page 1 of 4 1 2 3 4

Search: Search took 0.03 seconds.

  1. Thread: Paragon Bass

    by Guenter
    Replies
    19
    Views
    2,581

    I had a newer Paragon with LE15A for several...

    I had a newer Paragon with LE15A for several years and indeed there was much less bass than even in AR3a bookshelf speakers I purchased to replace them. However, the paragon took to equalization to...
  2. Replies
    13
    Views
    1,345

    Great to know- thanks for the post........

    Great to know- thanks for the post..... presumably the other end of the bracket from the throat mounts at the back of cabinet. Doesn't appear to look like it’s 7” long to reach front baffle

    cheers...
  3. Replies
    13
    Views
    1,345

    Great advice and will take it to heart, glad to...

    Great advice and will take it to heart, glad to hear again that Iím not being silly to try this combination of drivers. Interestingly on checking inside the cabs this morning I can not fathom where...
  4. Replies
    13
    Views
    1,345

    .... ahhh, didnít realize there was a support...

    .... ahhh, didnít realize there was a support initially. Iíll look inside cabs tomorrow but donít think so. I purchased cabinets after seller has gutted them for the components to sell. I knew I...
  5. Replies
    13
    Views
    1,345

    .... many thanks to all for the advice, much...

    .... many thanks to all for the advice, much appreciated! I was hoping to do without having to go through the trouble of cumbersome braces but knew deep down it was not likely the best idea. With a...
  6. Replies
    13
    Views
    1,345

    Ahhh, OK, thanks. I assume the ply is 3/4" and...

    Ahhh, OK, thanks. I assume the ply is 3/4" and your driver is 5 lbs heavier than mine. I've got the original JBL L200B cabinets which seem to have been made of 3/4" MDF .... so probably of similar...
  7. Replies
    13
    Views
    1,345

    2482 in L200B cabinet

    Hello All ..... I've bought 2482 drivers with H93 short horn for my L200B cabinets. Horn fits just fine of course, the question is will the front panel support the weight/torque of the fairly heavy...
  8. Replies
    2
    Views
    601

    Mike, Great, makes sense. The perforated stack...

    Mike, Great, makes sense. The perforated stack came with 075 tweeters I purchased recently. Fits over the 075 nicely and a great idea I though in that dispersion should increase significantly while...
  9. Replies
    2
    Views
    601

    Perforated Lens Hole Allignment

    My stack of perforated plates have fallen out of the holder. Question is, do the holes in successive plates align in some way or are the holes in successive plates just randomly oriented. Seems I can...
  10. Replies
    4
    Views
    2,745

    .... I'm sure there is... :banghead: However...

    .... I'm sure there is... :banghead: However when searching the very general terms "L200B 375" (among others) essentially nothing came up except stuff about amplifiers and someone looking at an oak...
  11. Replies
    4
    Views
    2,745

    Drivers for L200B cab

    Hi All,

    I obtained a set of empty L200b cabinets and have a variety of drivers available to place in them. I'm a bit unsure of which to use so as to create an optimal system. So:

    1) should I...
  12. Replies
    17
    Views
    8,819

    First let me say, Glen was right on the money!...

    First let me say, Glen was right on the money! carefully inspecting all 4 drivers (consecutive serial #'s of course - probably confirming a 'special order') the drivers 'all' display fine scratching...
  13. Replies
    17
    Views
    8,819

    Hi Widget, I measured the DC resistance as 14.2...

    Hi Widget, I measured the DC resistance as 14.2 ohm with a few tenths of an ohm variation between each of the four LE15'B' that I have. I would assume the ac impedance will likely be a few ohms...
  14. Replies
    17
    Views
    8,819

    Zilch, I'm going blind.... didn't pick up on that...

    Zilch, I'm going blind.... didn't pick up on that huge cutout on your boxes .. :-) re the diffraction, I tend to think the same and will likely go ahead and check this once the tweeter is installed...
  15. Replies
    17
    Views
    8,819

    David, thanks, makes a lot of sense. Especially...

    David, thanks, makes a lot of sense. Especially in view that these woofers were used 'pair-wise' per side .... presumably to give the paralleled nominally then 8 ohm impedance for the LX5 xover that...
  16. Replies
    17
    Views
    8,819

    thanks for the kind replies. Note, I've added the...

    thanks for the kind replies. Note, I've added the pictures as suggested... I know, a picture is worth a thousand words - thanks for that suggestion.
    re the tweeters, the cabinet is lovely - great...
  17. Replies
    17
    Views
    8,819

    Yet another LE15 querry

    I've recently bought a L200B cabinet and am about to fill it with some of my components - seems I never get around to finishing my own homebrew and the cabinet 'is' lovely. Anyway, I've got some...
  18. Thread: JBL vs. AR

    by Guenter
    Replies
    27
    Views
    10,243

    All right, I'll be a heretic. From my admitedly...

    All right, I'll be a heretic. From my admitedly limited experience with both and I did make the choice and kept the AR3a's. The AR3a's are excellent speakers and, yes, better than the L100's - let...
  19. Replies
    13
    Views
    17,807

    Small bit of input re age of blue Le15a's. I...

    Small bit of input re age of blue Le15a's. I don't believe 'early' 60's is correct. I bought my very first Le15a that was blue in colour brand new in Vancouver in 1967 or 1968. the store was...
  20. Replies
    25
    Views
    9,437

    Hi Eckhard, not trying to make you feel down (if...

    Hi Eckhard, not trying to make you feel down (if that's what you meant). Just a reality check re your purchase; don't get me wrong - if I had to spare money and the room I'd love to have a Paragon...
  21. Replies
    25
    Views
    9,437

    Like Rafael I also measure my Paragons using a...

    Like Rafael I also measure my Paragons using a impulse measuring system now so common with computers. I found that the arrival times at a reasonable listening position between 075/375 very well...
  22. Replies
    28
    Views
    7,513

    that reminds me that I've always wanted to ask. ...

    that reminds me that I've always wanted to ask. What's the difference between having the slats angling down or angling up? I guess if the slats angle up it might catch more dust..... but otherwise?...
  23. Replies
    25
    Views
    9,437

    well I've had one for a number of years. it's an...

    well I've had one for a number of years. it's an 'interesting' but definitely not a great speaker IMHO. I doubt if it even is a good speaker. Blasphemy I know. I love the design and basic idea...
  24. Thread: Twin Woofers

    by Guenter
    Replies
    7
    Views
    1,852

    Sorry, didn't clue in to your (and others) exact...

    Sorry, didn't clue in to your (and others) exact response. Please let me ask re above to make sure I understand correctly. If a single speaker in a -say- 5 ft^3 box has a -3dB point of 40Hz and flat...
  25. Thread: Twin Woofers

    by Guenter
    Replies
    7
    Views
    1,852

    I don't know if its because the second woofer is...

    I don't know if its because the second woofer is so close to the floor (3 or 4 inches), or because I used one large enclosure instead of two sub-enclosures.

    Well, alhough I am not an expert, I...
Results 1 to 25 of 89
Page 1 of 4 1 2 3 4