And I found the JBL library link. Thanks again.
Type: Posts; User: RSchiller; Keyword(s):
And I found the JBL library link. Thanks again.
Hi and thank you, very helpful. "JBL Library" ?? Would you kindly provide a link to that site if it is online?
best, Rick
Hi, I have two sets of metal JBL speaker badges as shown, these have the metal posts on the rear - no velcro.
I'm curious what era these are from? Are the vertical ones older?
thanks to all!
I have not a clue.
Yes, I see that. Would be a substantial cutout.
Ok, thank you! The labels for the energizer cutouts, should there be an opening under them? They are completely solid, no opening.
And whether I'm right or wrong remains to be seen. What vintage are these components? 60s 70s? Thanks again. Rick
Ok, good information, thank you. Yes, they are LX10s - images below. I live in Oakland, CA and took the speakers to a local speaker repair pro; he checked them out and said they are in good working...
Pretty tough neighborhood around here. The image I posted is before the Lansolay was all removed obviously. It would be impossible to leave it and refoam as the new surrounds attach to the top of the...
Ok, I have attached some files.The components are as follows:
Matched Pair Walnut cabinet C53 Libra #64802 #64671
LE175 drivers 8ohm w/ 1217-1290 Horns. red seals intact
Driver: #9858 – 6.0...
Fair enough, I'll post some images tomorrow. Thanks.
They drop in from the front and there is a hole cut in the back so the rear of the horn extends c. 7/16." Looking down from above they appear to stick no farther out than the LX10 binding posts.
Hi, I have a pair of walnut Libra c53 cabinets loaded with LE14A woofers + LE175 horns + LX10 crossovers. Doing research online this seems to be the S1 component system loaded into the C53's. Is...
Hi
You first reply gave nicely detailed instructions centered about going slowly with MEK on Q-tips. Your 2nd replay about 8 minutes later appeared to be further reflection and contradiction but I...
Hi, Wagner. You left two messages and I take it the 2nd/later one is your opinion, that the lansolay is just too stuck on?
thanks
Rick
I have a pair of LE14Cs I am attempting to refoam. I purchased the kits from Rick Cobb. When I went to remove
the old lansolay surround, the aquaplas coating on the edge of the cone came up with it...
I acquired two pairs of C53 Libra cabinets. One pair is loaded with a hodgepodge of LE14C, LX2-1/LX2 crossovers plus LE175DHL and N1200 crossovers. Go figure. The other pair of cabinets is more...
My first post and I know little so hope this is correct venue. I acquired some older JBL parts and c53 Libra cabs. I have a pair of LE14A and a pair of LE14C speakers. I have a pair of LX2 (one is...