Search:

Thank you much for those who helped. And thank you for those who made me look stupid. This will be my last post in this forum..

????????????????????????

I know this a Lansing forum but I am hoping someone would know about these RCA 9449. I have a chance to buy these and just wondering if anyone would know the specs for these. How high can they go...

Alright. I am ready with my project. Thank you much everyone.

Best Regards,

Wow, this is way cool. Thank you very much John. I will make crossover following closely with this one. Will this yield an 8ohm load then even though the low frequency and midrange are wired in...

How should I wire my speakers in this configuration: I am running an 8" fullrange on open baffle and using a 15" with a large inductor crossing it at 100~200hz and also a helper tweeter with a 2uf...

Or Dual Voice Coil woofer and how do you hook them up.

Altec 9844 has 2 414 speakers wired in parallel and a 806/811 horn in each cabinet and they sound great..........though, it could be because 1 woofer is being used as bass driver by having a large...

well, the speakers are vintage but the baffle are homemade - i just dont want to waste a perfectly set of baffle. there are lot of sentimental value to its.

I have a pair of vintage 8 ohm full range speakers that sound really good on open baffle. Luckily, I just got another pair and thinking about adding these to the same baffle. What would this do to...

Thanks everyone for your help. I will play around mix/match drivers, etc...

OK - what about this. I will wire two 8ohm speakers together to get a 4ohm load - but would it ever dip way below that - say 2~3 ohm load. My little tube amp can handle 4 ohm load but I just worry...

Thank you all for your help and recommendation. Though my ears is set on my single ended triode 45 amp.

What ohm load will I get if I wire an 8 ohm and a 4 ohm in serial.

What ohm load will I get if I wire an 8 ohm and a 4 ohm in parallel

I understand that if I wire speakrs in parallel, I...

Thanks Zilch.....

I measured the old L-pad and I've got a reading of 15.2; Does that mean I should use a 16ohm L-pad to replace the old one.

I will measure mine and post the result here. Thanks everyone.

So which is it 8ohm or 25ohm. How would I measure it from my existing network. I can unsolder the 3 tab but dont know how to measure it. Thanks.

one of the shaft on my altec n-800-f is going bad. Does anyone know what is the value for this l-pad. Thanks.

I've tried them and they seemed to do OK - not much bass though . With my 2 watts amp, I really dont have much choice ;)

I got you - will get them tomorrow - I guess I can't lose for $10 a shot and use them for future projects. Also I will take you advise and just leave the set the way they are. I guess JBL mate...

Zilch,

I've searched long and hard but could not locate those horns anywhere. They must be out of production. Thanks for your help.

"O.K., you're asking in other threads whether they're suitable for home use.Is there something you don't like about the way they sound for that purpose?" I feel like they can sound lot better than...

These are from JBL G-734 cabinets that I got from a local thrift store. G135A-8 is a 15" woofer, horns are JBL 2371. You can view the specs here:
...

Can someone please educate me on this L-pad calculator thing:

According to this website:

http://www.carstereo.com/help2/Articles.cfm?id=18

My horn/tweeter JBL 2416 (4 ohm) driver is...