Hi,
Just finished the Nelson Pass L300 crossover for my latest speaker project. I assembled the crossover exactly as i see it on the schematic, with R3,R4,C4,L2,L3 soldered to a common point. On the...
Type: Posts; User: Barry H; Keyword(s):
Hi,
Just finished the Nelson Pass L300 crossover for my latest speaker project. I assembled the crossover exactly as i see it on the schematic, with R3,R4,C4,L2,L3 soldered to a common point. On the...
Hello,
Does anyone have a crossover schematic for these drivers? I was thinking of using the Lx 30 from the Loudspeaker Component Series, just add a 20uf cap across the low pass portion and tweak...
Positive its a 136H, pictures of it are posted on Canuck Audio Mart.
Looking to buy a pair of 136h woofers and the foam surrounds were installed with the surround on the front of the cone instead of the back. Looks
like the installer used a oversized foam surround,...
Thanks for the tip Baron 030. It was a loose L2 coil wire in the .5 ohm to 32 ohm x-over. Now i get the same readings in both crossovers.
Thanks again, Barry
Hello all,
When i cleaning my l-pads in my N7000 crossovers, i put a ohmmeter across the HF outputs and found a difference between the two. When rotating one, the readings range from .5 ohms to 32...
Hello all
Is there a schematic for the N1200 crossover that negates the use of the tapped inductor and uses an equivalent circuit instead?
I have considered using the 4333/S300/L300 equivalent...
I'm upgrading my N7000 to N8000 x-overs by adding resistors across the outputs and there is two soldering tabs off the HF (+) terminal. One tab has a green wire to the L-pad and the other has a red...
Just thought I would share more info on my crossover project. I have been researching this project for the past year on this forum & the internet. I plan on upgrading the N7000 to N8000 since i'm...
this is my first post .
I am planning a upgrade to my N1200 & N7000 crossovers and are considering using Auricaps capacitors. These are polarized capacitors and would there be any problem going from...