Search:

Type: Posts; User: porschedpm; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    2,132
    Views
    1,511,997

    Yes, you should designate the fronts as large and...

    Yes, you should designate the fronts as large and the surrounds/center as 'small'. Even if you were able to cross the HTPS400s at 40Hz, I think you'd be happier crossing them at 80Hz. At 40Hz there...
  2. Replies
    15
    Views
    11,139

    Hi, Mark. I've considered using one or two...

    Hi, Mark. I've considered using one or two 18Ti's as centers in my own system. How does it sound? Also how do you have them wired? in series or parallel?
  3. Thread: xpl90

    by porschedpm
    Replies
    5
    Views
    7,194

    I use a pair of XPL-90s as rear surrounds in an...

    I use a pair of XPL-90s as rear surrounds in an otherwise stock Performance Series home theater system. I use a Bryston 9B-ST THX to power them (100w/ch). They work perfectly for the application I'm...
  4. Replies
    363
    Views
    283,828

    Like arguing one motorcycle is "better" than...

    Like arguing one motorcycle is "better" than another because its published top speed is higher. Specs don't tell the whole story especially when they're looked at in isolation of others. Oftentimes...
  5. According to the owner's manual for the Pass X-1...

    According to the owner's manual for the Pass X-1 preamp:

    "On the XLR connectors, pin 1 is grounded, pin 2 is the positive signal, and pin 3 is the negative signal."

    I looked in the owner's...
  6. Replies
    12
    Views
    13,797

    Your best bet may be to reassemble it and enjoy...

    Your best bet may be to reassemble it and enjoy it full range using one amp. Then worry about converting to bi-amp after you've figured out what amps and active crossover you'll use and how to...
  7. Replies
    17
    Views
    13,533

    Many integrateds have the capability to split...

    Many integrateds have the capability to split their pre-amp and amp sections. look for 'Pre-Out' jacks on the back of your integrated and if you have them you can use your integrated as a pre-amp.
  8. Replies
    7
    Views
    12,918

    One of my 18Ti's also had a subtle 'buzz' or...

    One of my 18Ti's also had a subtle 'buzz' or rattle as you put it. It wasn't very loud but once you heard it your ear would go right to it whenever that speaker was on. I isolated it to the woofer...
  9. You make a very important point, Widget. There...

    You make a very important point, Widget. There are many, many entrepreneurs in the US and worldwide looking for profit opportunities. If the potential to sell Japanese Market JBL's was great...
  10. Replies
    8
    Views
    5,320

    Open them up and find out.

    Open them up and find out.
  11. Replies
    18
    Views
    11,548

    In the process researching the screw sizes of the...

    In the process researching the screw sizes of the 120Ti, I found that I had all the correct screws I needed except those for the tweeters. I found some that would work at my local Lowes Hardware...
  12. Replies
    18
    Views
    11,548

    JBLPro had the woofer screws listed in their...

    JBLPro had the woofer screws listed in their parts list under part #804-01110-20. Don't know if they still have them or not. Last time I tried to get something from JBLPro I had to go thru an...
  13. Replies
    18
    Views
    11,548

    Thanks mac, allan, and 3db for the suggestions. I...

    Thanks mac, allan, and 3db for the suggestions. I went to the JBLPro website and found the following screw dimensions:

    Woofer: 10-32 x 1-1/4, FIL, PH, BLK ZINC, LCS

    Mid: 6-32 x 1, FLT, PH,...
  14. Replies
    18
    Views
    11,548

    Screws and Fasteners

    Not that I need another pair but I'm in the process of building up a pair of 120Ti. I've rounded up the cabinets, drivers and crossovers but I'm missing some of the hardware, specifically the screws...
  15. Replies
    4
    Views
    5,868

    Try raising them up off the floor about 30cm or...

    Try raising them up off the floor about 30cm or so. Have also heard of some people stuffing socks into the bass ports. However keep in mind a certain amount of bass "punchiness" is to be expected...
  16. Replies
    70
    Views
    120,120

    Awesome collection. Nice tip-of-the-hat to...

    Awesome collection. Nice tip-of-the-hat to Nelson Pass also.:coolness:
  17. Replies
    63
    Views
    34,962

    I think the 4412 Studio Monitors might be what...

    I think the 4412 Studio Monitors might be what you're looking for.
  18. Replies
    63
    Views
    34,962

    In the words of Emily Latilla: "Nevermind".

    In the words of Emily Latilla: "Nevermind".
  19. Replies
    63
    Views
    34,962

    It's been about 4 years since I owned a pair of...

    It's been about 4 years since I owned a pair of L65's. Back then I also was looking to upgrade them. The general concensus I got from forum members at that time was that the L65 is already closely...
  20. Replies
    53
    Views
    31,837

    I hear you 4645. Nobody's going to take my...

    I hear you 4645. Nobody's going to take my Betamax or 8-track player from me either.
  21. Replies
    64
    Views
    75,877

    Here's an anti-skate weight for a Pro-Ject tt,...

    Here's an anti-skate weight for a Pro-Ject tt, from the Needle Doctor. You might be able to make it work:

    http://www.needledoctor.com/Project-Anti-Skate-Weight?category=433

    This site has an...
  22. Replies
    8
    Views
    5,464

    Do you really need different spikes though? A...

    Do you really need different spikes though? A quick look at the owners manual indicates the spikes supplied with the speakers are good for both wood and carpeted floors. Here's an excerpt:

    ...
  23. Replies
    8
    Views
    5,464

    You might check the tech sheets at: ...

    You might check the tech sheets at:

    http://audioheritage.org/vbulletin/showthread.php?t=10661

    They don't give the actual dimensions of the thread but they at least give a part number:...
  24. Replies
    15
    Views
    11,298

    You might be asking the 128H to do something it...

    You might be asking the 128H to do something it was not designed to do. In my experience the 128H is a very flat speaker and doesn't have an accentuated that, say, the 2214 or even the 2213 do. If...
  25. Replies
    15
    Views
    10,734

    When I started on this forum a few years I ago, I...

    When I started on this forum a few years I ago, I was in the same position as you. I had a pair of L65's, loved them dearly not only for their great JBL sound but also for their wonderful...
Results 1 to 25 of 494
Page 1 of 20 1 2 3 4