Search:

Type: Posts; User: Woofer; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Good luck bedrock. I'm lucky enough to have a JBL...

    Good luck bedrock. I'm lucky enough to have a JBL SA660 amp, which just happens to have a 'TEST' function switch on the front panel, which tests if anything is out of phase. With one of the woofers...
  2. Richard, what makes it even more difficult for...

    Richard, what makes it even more difficult for me, is that I have the JBL 4312A Monitors, but cooked both the woofers when an amp went DC. Here in Australia, the 2213H are impossible to source, so I...
  3. Certainly looks that way. But this raises the...

    Certainly looks that way. But this raises the question, does this also apply to the mid drivers? Might have to pull mine out and check, but, another day....
  4. An excellent post Richard. Thank you heaps for...

    An excellent post Richard. Thank you heaps for that. Woofer.
  5. According to the schematics for the x-o,...

    According to the schematics for the x-o, green/black to -ve. But then again, does that mean the black terminal??????
  6. Hi Richard,Incorrectly wiring the polarity, just...

    Hi Richard,Incorrectly wiring the polarity, just isn't possible unless you physically swap the braids over which would result in them crossing over each other.. They'd short out in no time.I'm...
  7. Woofer 2213 H positive or negative transducer ?

    This is an old thread, but I thought I'd add this extra bit.I just purchased a pair of 2213 [Alnico] to replace a pair of dead ones, and although they are both original, they are opposite in polarity...
  8. Replies
    9
    Views
    20,280

    I'll pop my head inside and have a look tomorrow....

    I'll pop my head inside and have a look tomorrow.
    You might be on to something there.
    Thanks for that....
  9. Replies
    9
    Views
    20,280

    Hi Rob. Good to see you're still hanging about...

    Hi Rob.
    Good to see you're still hanging about here. ;)
    Thanks for that, but the problem runs deep. This unit came back from a gig once and wasn't used again for a while.
    After powering up one...
  10. Replies
    9
    Views
    20,280

    Thanks for that, but sorry for asking, how do I...

    Thanks for that, but sorry for asking, how do I enter that?
  11. Replies
    9
    Views
    20,280

    10 years later, and I'm still looking for an...

    10 years later, and I'm still looking for an answer to that question.... :(
  12. I've PM'ed you.:)

    I've PM'ed you.:)
  13. Replies
    11
    Views
    3,678

    That is my Bobby. A terribly handsome Tuxedo....

    That is my Bobby. A terribly handsome Tuxedo. He's gone now... but lives on thru' my avatars in the 'virtual world' out there somewhere..... I miss him heaps.

    I tip my hat to your wife. What a...
  14. Replies
    11
    Views
    3,678

    Yep, that was gonna be exactly my suggestion too!

    Yep, that was gonna be exactly my suggestion too!
  15. Replies
    11
    Views
    3,678

    Have you ever had them set up vertically just on...

    Have you ever had them set up vertically just on the floor without the 'stands'?
  16. As long as the voice coil lines up in the gap of...

    As long as the voice coil lines up in the gap of that top plate you should be good.
    How did you go with fixing the pole piece?
  17. Warning: If you break the hammer, you're hitting...

    Warning: If you break the hammer, you're hitting too hard. Best of luck Mazza. Let us know how you go. :)
  18. OK. I hope you can make sense of this... One...

    OK. I hope you can make sense of this...

    One way of re-centering a pole piece without having to demagnetise, is to stick a credit card down the opposing gap, make sure it's exactly opposite the...
  19. Replies
    78
    Views
    117,947

    Thanks heaps Widget..... :bouncy:

    Thanks heaps Widget..... :bouncy:
  20. Replies
    78
    Views
    117,947

    You have to remember that 'most' of 'em are...

    You have to remember that 'most' of 'em are pretty young, so to them 90's IS vintage.... ;)
  21. Replies
    78
    Views
    117,947

    I was dreadfully ill and diagnosed with stage 4...

    I was dreadfully ill and diagnosed with stage 4 non small cell lung cancer, and given 2-3 months.
    The shock was devastating.
    After some (very fast) research, I discovered my hospital was starting...
  22. Replies
    78
    Views
    117,947

    This place whilst maybe not all that busy, is...

    This place whilst maybe not all that busy, is still the #1 source for ANYTHING JBL or Lansing.
    It would take 3 or 4 lifetimes to go through all the wealth of info here. I still come and go here...
  23. Replies
    49
    Views
    43,932

    Absolutely excellent work droh. Truly...

    Absolutely excellent work droh.
    Truly outstanding.

    There's a pair here in Sydney Australia that could do with some rescuing.
    I'd give 'em a go, but they're just in the wrong place at the wrong...
  24. Replies
    2
    Views
    2,795

    Oh thank you so much Pellets. You must be the...

    Oh thank you so much Pellets.
    You must be the only person in the whole world that had this schematic.
    I had looked almost everywhere.
    You're an absolute marvel.

    Cheers lots n' lots.....
    ...
  25. Replies
    2
    Views
    2,795

    JBL SE401E schematic wanted... [please!!!!]

    I have a JBL SE401E amplifier that needs some TLC.
    When powering up, there's a loud 'buzz' coming equally from both channels.
    I've searched and searched, but can't find a schematic for it...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4