Search:

Type: Posts; User: duaneage; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.26 seconds.

  1. Replies
    273
    Views
    179,588

    Sticky: Work for Bose and really get even. When they...

    Work for Bose and really get even.
    When they hustle you out the door it's really personal
    One minute you are a part of something then your an outcast
    i went through that 7 years ago and today...
  2. Thread: Crown Amps

    by duaneage
    Replies
    136
    Views
    99,710

    I just got a Crown XLS 1000 and I am very happy...

    I just got a Crown XLS 1000 and I am very happy with it. Only 11 pounds. The internal fans don't come on even under hard use and it has RCA inputs as well as balanced. The amp has internal crossover...
  3. Thread: Box for 2213H

    by duaneage
    Replies
    2
    Views
    1,967

    Forget vents for those drivers. A sealed box is...

    Forget vents for those drivers. A sealed box is probably best and that would be 2.5 to 3 cu ft for each driver

    that would be about 100L a piece but if you stuff your 54l box with fiberglass or...
  4. Copying another system has it's pitfalls too. The...

    Copying another system has it's pitfalls too. The crossover network affects the box tuning a lot so if better or worse inductors are used the box needs to reflect the new Qts and Qes which results....
  5. Replies
    6
    Views
    4,359

    That cable should work fine at audio frequencies...

    That cable should work fine at audio frequencies and power levels.
  6. I've had a 120x-ds for about 25 years, mine is...

    I've had a 120x-ds for about 25 years, mine is the home version. It has 4 bands of adjustable gain which allows fine tuning of where the bass is augmented. There is a full range or high pass switch...
  7. I would start with a sweep of the driver to...

    I would start with a sweep of the driver to determine the resonant frequency of the drivers you have. Don't rely on published specifications, measure it. Then once you have Fs start at 3 times that...
  8. Replies
    10
    Views
    13,102

    If your repair shop can't troubleshoot a preamp...

    If your repair shop can't troubleshoot a preamp using plug in op-amps that are identical throughout then I would find another shop. They aren't that complicated.
  9. Replies
    3
    Views
    4,165

    I built many a system with the 2214 H. I also...

    I built many a system with the 2214 H. I also have a pair of L100T speakers. Let me tell you what I know about them.

    The design software usually specs a 1.7 Cu ft box tuned to around 50 hz. This...
  10. Replies
    3
    Views
    1,277

    Get the 2.7 and wind it up to 2.8 by adding wire...

    Get the 2.7 and wind it up to 2.8 by adding wire of the same gauge and giving it a few turns while measuring the value.
  11. Replies
    49
    Views
    29,779

    Here is a tip for the screws .... I use gun...

    Here is a tip for the screws ....

    I use gun blue to blacken screws. It gives a great durable finish that is dark enough. Won't work on stainless or zinc. Great restoration on the cabinets, it's...
  12. Replies
    247
    Views
    72,793

    Might be easier to just play the instruments...

    Might be easier to just play the instruments yourself. Eliminate all electronics that way.
  13. Replies
    6
    Views
    7,330

    The 128H and the 2214H are very similar except...

    The 128H and the 2214H are very similar except for the obvious cone difference. I've built a lot of systems with both and prefer the 128H, hands down. It produces better bass in a smaller box whereas...
  14. Replies
    4
    Views
    1,492

    I would look at the brass connectors on the...

    I would look at the brass connectors on the drivers, they might have bad connections. I replace them with new connectors made from alloy not brass.
  15. Thread: RIP Zilch

    by duaneage
    Replies
    98
    Views
    46,467

    I need to connect more on this site, been busy...

    I need to connect more on this site, been busy doing too much else.

    Zilch just wasn't a guy posting about speakers, he was a reference and store of knowledge that seemed boundless.

    I can't...
  16. Replies
    8
    Views
    6,052

    I got double refined MDF free of formaldehyde...

    I got double refined MDF free of formaldehyde from Russel Plywood in New Castle Delaware. They stock 1 inch and can get up to 2 1/8" special order. 240lbs a sheet. I like the double refined since it...
  17. Replies
    7
    Views
    3,187

    I've reworked numerous L100T crossovers to...

    I've reworked numerous L100T crossovers to L100T3 specs. There are at least three versions of the original L100T network, two on PCB and one with wire posts, and all have the same part number.

    I...
  18. Replies
    10
    Views
    5,303

    The one pictured is mine. You can also add...

    The one pictured is mine. You can also add external values too. Two of these can be chained for steeper slopes or complicated designs. Phase can be reversed with a switch, Zobels can be connected as...
  19. Thread: 4319 Monitor

    by duaneage
    Replies
    13
    Views
    4,790

    But you are getting new drivers and probably...

    But you are getting new drivers and probably better drivers than anything else out there.

    Don't forget the VAT tax in Japan, I think it is 10 percent. You can get that dropped by waving your...
  20. Replies
    8
    Views
    3,521

    I might get a tomato thrown at me for saying this...

    I might get a tomato thrown at me for saying this but you might want to look at different brands today for new drivers. JBL isn't really into the home builder market any more. If you can look past...
  21. Thread: 4319 Monitor

    by duaneage
    Replies
    13
    Views
    4,790

    Yeah, no one in the US is interested in blue...

    Yeah, no one in the US is interested in blue monitors any longer. :bs:

    There must be another reason for the sky high prices of the used ones from 25 years ago.

    Here's a marketing idea: Offer...
  22. Replies
    10
    Views
    5,303

    I use a crossover breakout box to simulate...

    I use a crossover breakout box to simulate crossover parts and quickly substitute values. I also have a 4 channel amp and 3 way electronic crossover I use to test the crossover points, attenuation,...
  23. Replies
    63
    Views
    39,074

    I think I found the place to take the wife and...

    I think I found the place to take the wife and kid for a weekend. I even have a place to stay at in Dobbs Ferry so we don't have to drive back home
  24. Replies
    23
    Views
    13,691

    THe heresy is a good speaker that can be tweaked...

    THe heresy is a good speaker that can be tweaked a bit to improve the midrange qualities. It's a durable system that can play very loud. I've owned Klipsch and find them to be different speakers in...
  25. Replies
    179
    Views
    62,476

    ROTFLMAO I wonder if Blue or Green fuzz works...

    ROTFLMAO

    I wonder if Blue or Green fuzz works better and should the lights be on or off in the room?
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4