Search:

Type: Posts; User: Mr. Widget; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 1.27 seconds.

  1. Replies
    66
    Views
    2,674

    I didn't dive into the full analysis that LARSA...

    I didn't dive into the full analysis that LARSA offered. When I saw the very narrow peak at whatever frequency it was, can't remember now, I popped my Meyer Sound PEQ in the system and dialed in the...
  2. Replies
    66
    Views
    2,674

    Boy, are we off topic!

    I understand where you are coming from and agree with your overall premise, that we typically intentionally or unintentionally tweak our DIY endeavors to suit our tastes and the effects of our...
  3. Replies
    16
    Views
    168

    No, the 3800 is just a 3600 with a Dolby FM...

    No, the 3800 is just a 3600 with a Dolby FM circuit in it. I virtually never used the Dolby bit.

    The way my set up was, 3800 to the pair of AudioArts 2100A Crossovers, from there the signal went...
  4. Replies
    16
    Views
    168

    A couple of lifetimes ago when those Culver City...

    A couple of lifetimes ago when those Culver City built Marantz units were new, I had a 3800 preamp and 510 amplifier. I used them in a tri-amplified system with a pair of Audioarts active...
  5. Replies
    44
    Views
    1,633

    I have recently taken level measurements of the...

    I have recently taken level measurements of the various drivers to get them within 0.1dB between the left and right channels. After doing that and listening a bit more critically, I made my first...
  6. Replies
    44
    Views
    1,633

    Unfortunately I don't remember. I did all the...

    Unfortunately I don't remember. I did all the design work over a decade ago! If I fire up CLIO, I'll measure it for you. I believe I tuned it at around 40Hz.

    If I could have lived with a larger...
  7. Replies
    5
    Views
    742

    The answer is in post 2 and quoted in post 3. ...

    The answer is in post 2 and quoted in post 3. The answer in mm is 104.8mm diameter by 266.7mm long.


    Widget
  8. Replies
    66
    Views
    2,674

    While in principle I agree with your logic, you...

    While in principle I agree with your logic, you fail to take into account that no sophisticated measurements were taken. What effects did the network have on impulse response, phase response,...
  9. First, I’d like to say I totally understand what...

    First, I’d like to say I totally understand what Clark is getting at. A very simple “full range” speaker powered by a very simple system can be very magical and give you a clear window into the...
  10. There is so much to unpack here. I am not going...

    There is so much to unpack here. I am not going to dig into each piece of gear you mention, but will give you my opinions based on my personal experience. My first active system was back in the late...
  11. Replies
    13
    Views
    296

    Maybe he likes quotes? ;) I wouldn’t make too...

    Maybe he likes quotes? ;) I wouldn’t make too much of it.

    Do you like the speakers? Ultimately that’s how I judge a speaker. I either like ‘em and they’re keepers or they aren’t.


    Widget
  12. Replies
    19
    Views
    1,701

    I still have a roll, but for those interested,...

    I still have a roll, but for those interested, the phone number for Wrap-on is 708-496-2150 and the product is item number 16550. This is for the 24" wide, 1" thick roll that is 50' long. If anyone...
  13. Replies
    19
    Views
    1,701

    I have performed objective and subjective tests...

    I have performed objective and subjective tests on fiberglass and polyester “poly fill” and the polyester, while much easier to work with is significantly inferior to the fiberglass material from a...
  14. Replies
    8
    Views
    3,521

    I bet in addition to personal preference, the...

    I bet in addition to personal preference, the woofers being used will also affect your results. Some woofers require more back EMF control from the amp than others.


    Widget
  15. Thread: Vintage VOT

    by Mr. Widget
    Replies
    1
    Views
    251

    Sure, I have two in my basement... just kidding....

    Sure, I have two in my basement... just kidding. :D

    I’m sure that there are collectors who have saved some.


    Widget
  16. Replies
    4
    Views
    269

    I am not personally familiar with the Altec 299...

    I am not personally familiar with the Altec 299 drivers... by all accounts they are very good, but to get the most out of them you’ll need to get a compatible horn with a low cut off frequency, you...
  17. Replies
    44
    Views
    1,633

    Road trip! Napa Valley is near by and is...

    Road trip!

    Napa Valley is near by and is beautiful in September/October. Come on up.


    Widget
  18. Replies
    4
    Views
    269

    Welcome to the LH Forum. The parts you...

    Welcome to the LH Forum.

    The parts you mention are potentially somewhat compatible. Hooked up properly and not driving the amp excessively, you should be able to play around with these parts and...
  19. Replies
    5
    Views
    262

    I think most of us have been there. Because of a...

    I think most of us have been there. Because of a similar experience I will not use T nuts. I use brass threaded inserts. I’ve had much better luck with them.


    Widget
  20. Replies
    44
    Views
    1,633

    Thanks... man-years is more like it! :D ...

    Thanks... man-years is more like it! :D

    Actually, while the veneer is from a Californian tree, I purchased it from Oakwood Veneer in Michigan. They are extremely helpful. I exchanged numerous...
  21. Replies
    44
    Views
    1,633

    :rotfl: While I think on-line speaker videos...

    :rotfl:

    While I think on-line speaker videos are pretty much pointless exercises, I also don't have any equipment that can do that.

    Now, that said, if you are in the area visiting, shoot me a...
  22. Replies
    44
    Views
    1,633

    Thanks everyone for the compliments! Sitting...

    Thanks everyone for the compliments!

    Sitting here listening to them does make the hours and hours of sweating the details seem worth it. Now there is only the memory of the smell of the Claro...
  23. Replies
    44
    Views
    1,633

    And now here they are in the house! Widget ...

    And now here they are in the house!


    Widget

    .
  24. Replies
    44
    Views
    1,633

    I found some very nice looking California Claro...

    I found some very nice looking California Claro Walnut veneer. It was accepted by the home’s “design director and artifact curator.” I was told that grilles must be installed over those round things,...
  25. Replies
    44
    Views
    1,633

    In 2007, I also moved from my workshop and loft...

    In 2007, I also moved from my workshop and loft in SF to a more traditional and much smaller home. I initially set up my prototype Project Widgets in the living room but due to their size (mostly...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4