Did he already turn his DD66000s on their side?
Printable View
I assume you discovered FMP = Frequency, Magnitude, Phase info in text format ...Quote:
What is an FMP file??
(basic info that can often be exchanged between speaker design/measurement programs)
Have fun while you're in there :)
Merry Christmas.
Thanks for this information about the GT active crossover.
I'll have a look at it when I find the time.
The last weeks I tried to refine the passive network in LEAP. I'm done at the moment and can't continue until I have the real thing here. Looks like a 99dB design and impedance is not lower than 3.6 ohms. The implementation of the 045Be isn't that problematic. The UHF will slightly roll off to 3 dB down between 20 kHz and 50 kHz. I'm not really worried about that :p
I'm sure your 1500AL/476Be/H4338 design sound wonderful. I already have a 1x1500AL + 2435 + H4338 design since 3 years now, remember?
This time the 2 woofer setup is a given as the EV2 cabinets are already in production.
I want to refresh this thread as my EV2 cabinets will be here in september/october and I need to lift my a$$ now and build prototype networks to be refined in use with the actual speaker.
Giskard, when converting the schematics from 1501AL to 1500AL, what DCR's did you use?
E.g. the two 10mH subwoofer coils together are 1.3 ohms in the original network.
The mod network use only one 10mH coil. 0.65 ohms? 1.3 ohms?
Same for all othe coils.
What do you think