Originally Posted by Earl K
Still :
- The LCR notches will still need to be tweaked to properly zone in on the peaks produced by your specific 2426 drivers. Additionally, because the DCR values of the coils in the mkII are unknown, the notches are likely going to end up deeper ( from a custom Solen build ) than they ought to be ( unless you transport a speaker over to Solen so that they measure the results as they go along ).
- Also, my own preference would be to redesign the padding network to simplify it, to make it conform with what I perceive to be , more typical Northridge network design practices ( I'm a liitle uncertain if this network is GTs' handiwork or someone elses / it looks to be someone elses through my wandering eyes ).
- Also, this mkII network may benifit from having a LCR impedance correction network added to it ( as is found in the original N3100 ). This means someone needs to build the mkII network / measure it's overall impedance with drivers in place / then decide if the LCR impedance correction is applicable .
:)