Quote:
Originally Posted by Kartsmart
2441 were avaialble as 8 ohm or 16 ohm units, H OR J designations.
my drivers measure 8 ohms so I should have 16 ohm Dia. ?
> If your 2441s measure 8 ohms (dcr), then you don't need new diaphragms for your drivers to work with the N3155 .
> I just measured the DCR for (3) 2441 drivers . They are all @ 8 ohms dcr .
> BTW, though the 2441 ( could be said to carry a "J" ) designation ( in todays parlance ) , but it didn't ( historically ) .
> It was simply known as a 2441 ( period, end of story ).
> The 2441 was only available with a single impedance ( aluminum domed ) diaphragm .
:D
> The "H & J" designations didn't come into being until the introduction of the ferrite versions of these Pro drivers.
> That designation never existed in the days of "everything Alnico" .