Printable View
this quetion has probably been asked a 1000x but I searched the forum and couldn't find the answer.
I bought my first pair of JBL's - L300's on ebay. they are enroute..........:D
I want to buy a high quality speaker cable but could not figure out what size fits in the push button connector.
I downloaded the brochure and manual but didn't see recommended info on wire size or if you can use some type of connector.
Any advice would be appreciated....
I have a couple pairs of large JBLs and didn't like the original connectors.Quote:
Originally Posted by d16rr702
I have changed them over to 5 way binding posts from Parts Express.
This gives me a lot more freedom with wire sizes -
I use banana connectors on the ends of the cables.
this is a good idea....I will start researching....Thanks!Quote:
Originally Posted by hjames
A found a picture of the panel I made for the back of my original L200s in '2006 ..
Small piece of thin plywood drilled and color-coded for + and - polarity.
The L200s were 2 ways - woofer and (short) horn midrange, and I set them up with an external crossover - so the upper pair fed the horn tweeter, the lower pair fed the woofer. I had another box on top for the slot tweeter, so they were like DIY L300s. I saved the original panel for any would be collectors.
Attachment 51956
nice pic, that makes sense....I guess I will keep the original crossover but I like the idea of jut making a new panel and keep the old one.
I'm just getting into this hobby so I really appreciate the ideas and attention.
http://www.parts-express.com/pe/show...number=100-030
This 10 AWG wire is available in different lengths but won't fit anything but the 5 ways Heather mentioned without using something like these;
http://www.parts-express.com/pe/show...umber=091-1255
I use dual banana plugs on both amp and speaker ends and the pins where needed.
http://www.parts-express.com/pe/show...number=091-334
Nice, thanks Don