I'm considering using a 2 channel Crown XLS and running a 4 ohm load on one side and an 8 ohm load on the other side. One channel would run a pair of subs and the other a single full frequency center channel for a HT.
Is this a bad idea?
Thx.
Printable View
I'm considering using a 2 channel Crown XLS and running a 4 ohm load on one side and an 8 ohm load on the other side. One channel would run a pair of subs and the other a single full frequency center channel for a HT.
Is this a bad idea?
Thx.
no
all of this is explained in the manual(s).
sub