1 Attachment(s)
Cross section of 1x2 inch walnut edge pieces
Quote:
Originally Posted by
JBLPRO
...Can't quite picture the relief groove and you say you installed them after the boxes were assembled? any build pics you can share...
mk
Attachment 86669
This is a crude drawing of the cross section of the 1x2 inch solid walnut edge pieces with the 1 inch radius. The relief groove on the flat side ensures that the narrow lip close to the radius end presses tight against the edge of the veneer. Hope this makes sense. I'll post more pictures of actual construction. I used a rather unusual method of constructing the boxes. I used to have a small sawmill so I had a bunch of red oak on hand that I milled into 3/4 x 2 1/4 pieces for joining the sides of the boxes. I used a lot of "Kreg Jig" construction as you will see in the pictures to follow. And I did use one small piece of particle board on the top of the boxes. The rest of the sides are all Baltic Birch.
Tom