View Full Version : n-3000 xover schematic for 601c Altec
hmolwitz
09-20-2005, 12:58 PM
I recently picked up a pair of 601c with no crossovers, does anyone know where I can find a schematic for these, or an inexpensive set of them?
Thanks
Harry
Robh3606
09-20-2005, 03:45 PM
Hope this helps you out
Rob:)
hmolwitz
09-20-2005, 05:46 PM
Thanks, that is quite remarkable, but after closer examination the crossover that matches these is the n-3000e, What could the difference be?
The 601a shows up in the 1954 catalog and I see the 601c in the 1963 catalog.
I understand the 3000 denotes the nominal crossover frequency.
Thanks
Harry
Robh3606
09-20-2005, 06:35 PM
Sorry but I can't help you there. That's the only schematic I have. Maybe the guys at Great Plains Audio can help you.
http://www.greatplainsaudio.50megs.com/
Rob:)
Nibeskov
02-03-2012, 12:17 PM
I recently picked up a pair of 601c with no crossovers, does anyone know where I can find a schematic for these, or an inexpensive set of them?
Thanks
Harry
Hi!
Here, look a photo54690
soundguy64
12-19-2018, 10:44 PM
Hi!
Here, look a photo54690
Many thanx for that schematic, Nibeskov! :applaud:
I got most of it from tracing wires inside one of my N-3000-E networks, but couldn't see what was going on with that tapped coil through all the goop that Altec stuck down the components with.
Thanks again!!:hurray:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.