PDA

View Full Version : Signature Logo



Bruno GINARD
08-10-2003, 08:18 AM
I would like to reproduce the original, but undiscoverable, “JBL Signature” badge. (To touch up my Hartsfields)

If anybody, owning those models, and a scanner, could send me an exact scaled picture …….:D


Regards

Bruno

GordonW
08-12-2003, 12:02 AM
Man, I KNEW I should have taken a close-up of the badges on my C36 Viscounts before I wold them.

I'll see if any of the pictures I have, are remotely high-resolution on the badge. I may have "accidentally" taken a semi-close-up, when I photo'd them to put them up for sale...

Regards,
Gordon.

John Y.
08-14-2003, 03:02 AM
Bruno,

Attached is a drawing that I made using a photo of the JBL badge. The badge is located on the lower right corner of the front panel on my Hartsfield. The center of the circle is 95 mm from the right edge and 70 mm from the bottom edge of the panel. Measurements of the badge were made with a vernier caliper. The badge is 1,5 mm thick and is bronze in color. There are two cast pins on the back of the badge which fit into pre-drilled holes in the front panel and slips out easily.

Hope this gives all that you need.

John

Bruno GINARD
08-14-2003, 07:21 AM
Thank you SO much John for your work....:)