View Full Version : Which one?

05-04-2005, 04:19 PM
Little ID help?

Board is marked with a "45" circled- no p/n that I can see- is it on one of the components? Posts are twist-type. L-pads are the usual.


05-04-2005, 04:23 PM
Give me the inductor values. My first guess would be an N96/N112/N150A variant.


6 uF?
13.5 uF?
4 uF?

Yeah, from inspection it should be one of the above.

2.5 mH iron core
0.75 mH air core
0.30 mH air core
3.5 mH 7.5 ohm air core

05-04-2005, 04:25 PM
far end is .3mh

middle (small one) is 3.5mh

one turned on it's side is ? marking is in the glue. It has the most windings of the three.

That's what I thought too- 150's or 96's... but was not sure since they look just a bit dif from the ones in my L96 and L150A.

Damn, you're good! Fastest Network ID in the whole midwest!

05-04-2005, 04:28 PM
Yep, N96/N112/N150A variant. You should be able to find the tech sheets elsewhere on the forum if you need them.




Yeah, they varied. Some came with a big 2.5 mH air core and some came with PC boards. My guess is that's from an early L112.

05-04-2005, 04:33 PM
Good to have ANOTHER spare then...:blink:

If anyone REALLY needs them for a 4313B mod, let me know. 3 pairs are enough for me... the fourth can go to a new home. If not, I'll add to the collection.

Thanks Giskard... I knew you would know just by looking for a few seconds.