View Full Version : 4311 Port Tubes
rek50
03-25-2005, 01:16 PM
I recently aquired a pair of 4311 PT's. In the component exploded view (Thanks Bo) there is a "Donut" shown on the end of the tube. What is it? Does it do anything for the sound?
boputnam
03-26-2005, 06:42 PM
I believe that is a wrap of fiberglass. It's a good idea to wrap the entire duct thusly - adds back virtual volume for some of that consumed by the duct.
A simple roll of plumber's pipe / duct wrap will do - couple inches wide, and secure with some tape.
bob newton
03-26-2005, 07:24 PM
Bo is absolutly correct. I have a pr of 4311's less drivers, so I looked and YEPPERS, thats whats there. Insulation on the top half of the 90 degree elbow.
With paper tape , one turn around the middle to hold the insulation there. :D
rek50
03-27-2005, 08:02 AM
Thanks! As always, I'm VERY impressed with all the Knowledge/Help on this site. There's SO many aspects to Hi-Fi sound. I've been reading here for over a year, trying to grasp some of the "Fine" details.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.