PDA

View Full Version : Lancer 77 Network Help



Bamadawg63
01-28-2005, 09:44 AM
I am in the process of redoing the surrounds on a pair of Lancer 77's and I would also like to rebuld the Xover while I have everything out. I want to keep the attenuator but put the Xover components outside the current network box and mount them on Xover boards inside then just wire it to the attenuator. I would like some help on what to use when rebuilding the Xover - I know the specs on the resistors because they are marked - but after reading the spec sheets here about the specialized caps used, I could use some help on what to use in place of the orig. Mylar cap inside, and also suggestions from others that have rebuilt this network. Any help is greatly accepted.

Cheers...
Nate

4313B
01-28-2005, 10:10 AM
Here are the parts you want :

Two of these - http://www.partsexpress.com/pe/pshowdetl.cfm?&PartNumber=027-427

Two of these - http://www.partsexpress.com/pe/showdetl.cfm?&DID=7&Partnumber=027-700

Two of these - http://www.partsexpress.com/pe/pshowdetl.cfm?&DID=7&Partnumber=266-814

Four of these - http://www.partsexpress.com/pe/showdetl.cfm?&DID=7&Partnumber=004-5.1