View Full Version : Replacing foam in 2421A's
Kay Pirinha
03-31-2019, 02:25 AM
Hi,
out of curiosity I've removed the back of one of my 2421A compression drivers yesterday in the afternoon. What should I say? As expected, I've found the foam in the inside being degenerated, right before falling to dust:
83665
You see the imprints of both leads and two imprints that I did with my fingers to see if the foam would come out again immerdiately. It didn't :crying:.
Now, what should I do? Ist this foam still available from JBL/Harman? Or will any polyurethane foam of appropriate thickness do? Is it even better to replace it by felt?
Best regards!
macsic
03-31-2019, 04:07 AM
I used felt and it was perfect.
They used felt before foam replace it.
Kay Pirinha
03-31-2019, 08:38 AM
Well, as these drivers might be well over 30 years old, and as I had two sheets of 10 mm thick foam laying around, I decided to replace foam by foam. I think the new foam pads might survive me if they last another 30 years :D. This is the procedure:
After I removed the four screws and lifted the back cover, the drivers presented like this:
83673
Then I removed the black and red wires and the terminals. As my flat bed scanner makes scans in true dimensions, which a camera usually doesn't, I scanned the back cover:
83674
I printed the file, glued the print onto cardboard and cut out the black area:
83675
Using this template I drew the contours onto the foam sheets using a sharpie:
83676
Then I cut out the foam pads with sharp scissors:
83677
To be continued...
Kay Pirinha
03-31-2019, 08:50 AM
Removing the old foam goop and cleaning the cap's inside from contact cement turned out to be the most tedious part of the procedure. I used a spatula, a small brass wire brush and lots of ethylic. I decided that the job was done at this state:
83678
I applied new contact cement to either the cap's inside and the foam pads and let it dry for 15 minutes:
83679
During this time I disassembled and cleaned the other driver.
Then I glued the new pad into the cap:
83680
Snug fit, doesn't it ;)?
I reassembled the terminals, the wires and screwed the back to the driver again. Job successfully done!
I apologize to all of you who have done procedures like this one several times and feel bored :crying:.
Best regards!
Earl K
03-31-2019, 09:07 AM
Nice work!
:)
remusr
04-04-2019, 09:33 PM
That foam looks pretty stiff. I think the original is a polyurethane closed-cell foam, usually dark grey/green about 10mm. There is some discussion of open or porous cell vs closed or impermeable. Literature indicates for 1/4-1/2 inch foam of the same pore density (PPI), closed cell attenuates better below 500Hz, both are similar above 500. A higher PPI (Pores Per Inch, linear inch that is) absorbs lower frequencies, acoustical is usually 60+. Internet search expert!
Kay Pirinha
04-05-2019, 01:38 AM
No, this white foam isn't stiff. It's also polyurethane foam, not expanded polystyrene. I can't tell, though, whether it is open or closed cell. Right, it's pore densitity might not be that high as in the original foam, but as I plan to xover at 1 kHz, not lower, I don't mind.
Best regards!
remusr
04-15-2019, 10:17 PM
Closed cell does not absorb water. It is used for patio furniture cushions among other uses that water absorption would not be acceptable.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.