JBLPRO
04-07-2015, 02:38 PM
Hello Folks,
As a result of looking for cork gasket sets for my 4355 project I came across a nice product. This is the cork that adhears to the baffle board surrounding the speaker cutout. No endorsement here just a better solution then the $18.00 per speaker price I have seen a ebay. That would be $108.00 for the two 4355 cabinets. What I found is a 1/2" adhesive backed cork tape roll that is 1/16" or 1/8" thick and 50' long. Cost for 50' roll is around $8.50 + shipping. I think this is very close in spec to the original #20059 curved cork pieces that were included in the MA-15 kit. I am pretty sure there will be no issues making an arc out of this product. Since the speaker pressure will be holding it down it should be just fine.
http://www.amazon.com/Cork-Rubber-Stripping-Adhesive-25/dp/B008OIUQ9U/ref=sr_1_6?ie=UTF8&qid=1428441706&sr=8-6&keywords=1%2F2%22+cork+roll+adhesive
Any thoughts on this.....
mk
As a result of looking for cork gasket sets for my 4355 project I came across a nice product. This is the cork that adhears to the baffle board surrounding the speaker cutout. No endorsement here just a better solution then the $18.00 per speaker price I have seen a ebay. That would be $108.00 for the two 4355 cabinets. What I found is a 1/2" adhesive backed cork tape roll that is 1/16" or 1/8" thick and 50' long. Cost for 50' roll is around $8.50 + shipping. I think this is very close in spec to the original #20059 curved cork pieces that were included in the MA-15 kit. I am pretty sure there will be no issues making an arc out of this product. Since the speaker pressure will be holding it down it should be just fine.
http://www.amazon.com/Cork-Rubber-Stripping-Adhesive-25/dp/B008OIUQ9U/ref=sr_1_6?ie=UTF8&qid=1428441706&sr=8-6&keywords=1%2F2%22+cork+roll+adhesive
Any thoughts on this.....
mk