mbeards
08-23-2013, 06:34 PM
Hi Everyone,
I am not sure about the polarity to connect all of my drivers in a DIY Hartsfield project to keep the same phase. I am using 130A woofers, 2441 Compression Driver, and the 075 Tweeter.
For the three way system I plan to cascade the high frequency output of a 3115 (500Hz) crossover into the input of an N7000 Crossover which will then go to the 2441 and 075; thus creating the necessary bandpass filter for the 2441.
Any help on which way to connect all the drivers? I believe that the HF output on the 500Hz crossover will be out of phase with the LF bass driver. So do I only reverse the polarity for the 2441 since the HF output on the N700 will put the 075 back in phase with respect to the bass driver?
Also Is it recommended that I rebuild these crossovers with all new components and air core inductors?
Thank you
Matt
I am not sure about the polarity to connect all of my drivers in a DIY Hartsfield project to keep the same phase. I am using 130A woofers, 2441 Compression Driver, and the 075 Tweeter.
For the three way system I plan to cascade the high frequency output of a 3115 (500Hz) crossover into the input of an N7000 Crossover which will then go to the 2441 and 075; thus creating the necessary bandpass filter for the 2441.
Any help on which way to connect all the drivers? I believe that the HF output on the 500Hz crossover will be out of phase with the LF bass driver. So do I only reverse the polarity for the 2441 since the HF output on the N700 will put the 075 back in phase with respect to the bass driver?
Also Is it recommended that I rebuild these crossovers with all new components and air core inductors?
Thank you
Matt